Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Tools: Building a table saw from parts- your t
By:Jay Babina
Date: 4/27/2010, 10:54 am
In Response To: Tools: Building a table saw from parts- your thoughts? (Malcolm Schweizer)

Where will it sit? In a shop with no intention of having it move or in a garage and you plan to wheel it outside to keep the garage dust free?

If you want it mobile, I would use large wheels on on side like the portable Rigid saw has and leave the other side with no wheels. I have the portable Rigid and it rolls around easy and once it's set down it doesn't budge. I would forget casters. If it's going to sit in a shop and not moved, then that's a different story.

BTW: - just curious, how did this thing end up without it's cabinet and in pieces?

Messages In This Thread

Tools: Building a table saw from parts- your thoughts?
Malcolm Schweizer -- 4/26/2010, 1:11 pm
Re: Tools: Building a table saw from parts- your t
Jay Babina -- 4/27/2010, 10:54 am
Re: Tools: Building a table saw from parts- your t
Malcolm Schweizer -- 4/27/2010, 2:05 pm
Re: Tools: Building a table saw from parts- your t
Charles Leach -- 4/27/2010, 6:48 pm
Re: Tools: Building a table saw from parts- your t
graybeard -- 4/27/2010, 11:16 am
Re: Tools: Building a table saw from parts- your t
Jay Babina -- 4/27/2010, 11:29 am
Re: Tools: Building a table saw from parts- your t
Don -- 4/27/2010, 10:22 am
Re: Tools: Building a table saw from parts- your t
Bill Hamm -- 4/28/2010, 12:40 am
Re: Tools: Building a table saw from parts- your t
graybeard -- 4/28/2010, 9:36 am
Re: Tools: Building a table saw from parts- your t
Malcolm Schweizer -- 4/28/2010, 8:56 pm
Re: Tools: Building a table saw from parts- your t
Bill Hamm -- 4/27/2010, 1:04 am
Re: Tools: Building a table saw from parts- your t
Kudzu -- 4/27/2010, 8:39 am
Re: Tools: Building a table saw from parts- your t
Farback -- 4/26/2010, 3:25 pm
Re: Tools: Building a table saw from parts- your t
Robert N Pruden -- 4/26/2010, 8:59 pm