Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Strip: Problem laying strip onto internal stem
By:george jung
Date: 5/5/2010, 1:23 pm
In Response To: Re: Strip: Problem laying strip onto internal stem (Dean)

: You're going to do an end pour later anyway, right? And probably an
: external stem? Drive on.

I'd avoid the end-pour ; most don't do them anymore, just not necessary. Good way to add weight, however.

Messages In This Thread

Strip: Problem laying strip onto internal stem *PIC*
riston -- 5/4/2010, 12:02 am
Re: Strip: Problem laying strip onto internal stem
Terry Haines -- 5/8/2010, 6:30 pm
Re: Strip: Problem laying strip onto internal stem
Ken Blanton -- 5/5/2010, 10:34 pm
Re: Strip: Problem laying strip onto internal stem
riston -- 5/5/2010, 10:56 pm
Re: Strip: Problem laying strip onto internal stem
Bill Hamm -- 5/6/2010, 12:36 am
Re: Strip: Problem laying strip onto internal stem
riston -- 5/6/2010, 1:00 am
Re: Strip: Problem laying strip onto internal stem
riston -- 5/5/2010, 10:10 pm
Re: Strip: Problem laying strip onto internal stem
Glen Smith -- 5/5/2010, 10:24 pm
Re: Strip: Problem laying strip onto internal stem
riston -- 5/5/2010, 10:28 pm
Re: Strip: Problem laying strip onto internal stem
Glen Smith -- 5/5/2010, 10:41 pm
Re: Strip: Problem laying strip onto internal stem
Dean -- 5/5/2010, 10:58 am
Re: Strip: Problem laying strip onto internal stem
george jung -- 5/5/2010, 1:23 pm
Re: Strip: Problem laying strip onto internal stem
riston -- 5/5/2010, 10:08 pm
Re: Strip: Problem laying strip onto internal stem
Ian Johnson -- 5/6/2010, 7:25 am
Re: Strip: Problem laying strip onto internal stem
Bill Hamm -- 5/6/2010, 12:32 am
Re: Strip: Problem laying strip onto internal stem
george jung -- 5/4/2010, 1:59 pm
Re: Strip: Problem laying strip onto internal stem
Bill Hamm -- 5/4/2010, 1:28 am
Re: Strip: Problem laying strip onto internal stem
risto -- 5/4/2010, 7:00 am
Re: Strip: Problem laying strip onto internal stem
Bill Hamm -- 5/5/2010, 1:41 am