: You know the part where the project stops being fun? I hit that
: part today. It was one of those days where you spend all day
: doing a part of the project that you thought would take an hour,
: tops. Who would have thought that the toughest job of the whole
: project would be cleaning the strapping tape and it’s residue
: off of the deck and hull?

: Anyway, I could really use some help, and I have a couple of
: questions. First, the scenario: I started just peeling the
: strapping tape off (now that the inside seam is glassed and the
: deck and hull are firmly joined) but it didn’t come off
: cleanly. I started trying to rub it out with acetone, but that
: didn’t work very well, then I referenced Nick’s book and he
: said to use paint thinner, which was slightly more effective,
: but still a pain in the butt. So here are my questions:

: 1. Is there something that works better than either paint thinner
: or acetone to remove the fiberglass-reinforced strapping tape?

: 2. Do you think I screwed anything up by using paint thinner over
: acetone, considering I may still do a light skim coat after the
: outside seam is glassed?

: 3. What is the best way to clean the paint thinner off of the hull
: (assuming it is the best way to remove the tape and residue) so
: I won’t have any problems with later coats of epoxy?

: Thanks in advance for the help!!

Two ways, GooGone from any hardware store works, fairly slow but it works and usually won't hurt the underlying surface.

Or, go to an auto paint supply dealer and get the 3M automotive adhesive remover, works very well and is fairly fast.

You can also try WD40, it's a pretty good solvent.

Bill H.