Date: 6/13/2010, 12:18 pm
: I can't see how that idea of allowing the glass from the deck to
: overlap the deck has any advantages.
: I suspect that it will create a lumpy join. Epoxy will come down
: onto the part of the glass that overlaps. It will either soak in
: by capillary action or will dribble down as you wet out the
: glass on the deck. That will make it impossible for that bit of
: glass to sit flat.
: Why did you want to do it that way? I suspect that the problems you
: will have trying to deal with the lumpy bits of glass that won't
: sit flat will be much worse than any work people have to do to
: feather the edge of a strip of glass applied in the usual way.
: Although I am always willing to learn new ways of doing things, I
: can see some serious problems and I can't see any advantage at
: all.
The masking tape idea is a tried and true system that works well and is surprisingly easy. You only need to scribe the cloth with a sharp knife, being careful not to cut into the cured cloth on the hull. Then you pull the tape off and the cloth remnant comes with it. I recently used it on my daughter's Ganymede. You can see photos and description at http://twofootartist.com/ganymede-construction-notes/
-Wes
Messages In This Thread
- Strip: cutting fiberglass
victor druten -- 6/12/2010, 7:26 pm- Re: Strip: cutting fiberglass
Charles Robinson -- 6/12/2010, 8:31 pm- Re: Strip: cutting fiberglass
vic druten -- 6/12/2010, 9:49 pm- This might not be a good idea
Allan -- 6/13/2010, 2:56 am- Re: This might not be a good idea
Wesley Ewell -- 6/13/2010, 12:18 pm- Re: This might not be a good idea *PIC*
Mike Hanks -- 6/13/2010, 11:37 pm
- Re: This might not be a good idea
Mike Hanks -- 6/13/2010, 11:52 am- Re: This might not be a good idea
vic druten -- 6/13/2010, 10:38 am- Re: This might not be a good idea *PIC*
Etienne Muller -- 6/14/2010, 8:36 am- Re: This might not be a good idea
dave g -- 6/13/2010, 10:43 pm- Re: This might not be a good idea
Allan -- 6/13/2010, 5:59 pm- Re: This might not be a good idea
Allan -- 6/13/2010, 5:56 pm- Re: This might not be a good idea
george jung -- 6/13/2010, 7:30 pm
- Re: This might not be a good idea
george jung -- 6/13/2010, 11:34 am - Re: This might not be a good idea
- Re: This might not be a good idea *PIC*
- Re: This might not be a good idea
- This might not be a good idea
- Re: Strip: cutting fiberglass
- Re: Strip: cutting fiberglass