Re: Strip: varnish problem
In Response To: Re: Strip: varnish problem (victor druten)
: Ian, uh...had both knees replaced...same day...ouch! I can get in
: the cockpit...but..because of the metal knees..it takes about 38
: seconds to get out. Hmmm...eskimo roll not in my menu...darn it.
: However, someday..one of 7 grandkids could launch this booger.
Victor,
I would consider trying just enough heat to soften the finish if I were you, and I would do it in a small area. If it were me I would get in it and leave a few marks on it to help me remember a great trip. A roll may be out of the question but a wet exit close to shore may not be.
Messages In This Thread
- Strip: varnish problem
victor druten -- 9/14/2010, 9:54 am- Re: Strip: varnish problem
Rod Tait -- 9/15/2010, 11:10 am- Re: Strip: varnish problem
victor druten -- 9/15/2010, 1:58 pm- Re: Strip: varnish problem
Ian Johnson -- 9/15/2010, 6:35 pm- Re: Strip: varnish problem
victor druten -- 9/15/2010, 9:31 pm- Re: Strip: varnish problem
Bill Hamm -- 9/16/2010, 2:41 am- Re: Strip: varnish problem
Scott Baxter -- 9/15/2010, 10:14 pm - Re: Strip: varnish problem
- Re: Strip: varnish problem
- Re: Strip: varnish problem
Eric -- 9/15/2010, 6:33 pm- Re: Strip: varnish problem
victor druten -- 9/15/2010, 9:29 pm
- Re: Strip: varnish problem
- Re: Strip: varnish problem
- Re: Strip: varnish problem
Malcolm Schweizer -- 9/14/2010, 6:11 pm- Re: Strip: varnish problem
Bill Hamm -- 9/14/2010, 11:08 am- Re: Strip: varnish problem
Eric -- 9/14/2010, 11:42 am- Re: Strip: varnish problem
Bill Hamm -- 9/14/2010, 12:49 pm
- Re: Strip: varnish problem
- Re: Strip: varnish problem
- Re: Strip: varnish problem