Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: S&G: Knee baces (cut them out??)
By:John lasky
Date: 9/24/2010, 8:46 am
In Response To: Re: S&G: Knee baces (cut them out??) (Bill Hamm)

: How thigh braces work seems to me to have much to do with the
: overall cockpit shape. Some cockpits the braces are completely
: out of the way and you never notice them until you're locked
: into them, with others they are always in the way. Much I think
: has to do with how wide the cockpit is on the front part. Those
: with skinny pointed foreward ends have problems finding enough
: room for everything.

: Not sure what shape yours is?

: Btw, I really like secure thigh braces, gives one much more control
: over the boat, but it's entirely up to you :)

: Bill H.

hello again Bill and Wes,

Wes You have the same boat although yours is a strip top (very pretty ) anyway the cockpit front is pretty narrow (s&G version) Ill sit in boat and measure some points of contact. I may have enough contact with out the tabs as the front of the coaming is a tad narrow on the S&G version.

as I mentioned above I can't lift My knee up as there is not enough room , perhaps I can remove a small amount at a time untill it makes sence.

Hinged or removable braces?? (this one crossed my mind as well) get in boat and lock them in place swing them out if you want leg room or want to get out of boat. I wet exit just fine with the braces its getting in/out of boat that they impair the motion esp out.

"John"

I

Messages In This Thread

S&G: Knee baces (cut them out??)
John lasky -- 9/23/2010, 9:24 am
Re: S&G: Knee baces (cut them out??)
Bill Hamm -- 9/24/2010, 1:54 am
Re: S&G: Knee baces (cut them out??)
John lasky -- 9/24/2010, 8:46 am
Re: S&G: Knee baces (cut them out??)
Bill Hamm -- 9/25/2010, 1:47 am
Re: S&G: Knee baces (cut them out??)
John lasky -- 9/27/2010, 2:42 pm
Re: S&G: Knee baces (cut them out??)
Bill Hamm -- 9/27/2010, 8:27 pm
Re: S&G: Knee baces (cut them out??)
Wesley Ewell -- 9/23/2010, 11:22 am