Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Strip: Internal stem placement
By:Bill Hamm
Date: 10/4/2010, 12:52 am
In Response To: Re: Strip: Internal stem placement (Eric Anderson)

: It just occurred to me that if you make the internal stem in the
: triangular shape that Nick describes, your strip rests on the
: outer edge of the form.

If you taper the "triangle" shape correctly the strips lay flat on the faces of the stem. It takes a rolling taper to do that.

Bill H.

Messages In This Thread

Strip: Internal stem placement *PIC*
Eric Anderson -- 9/29/2010, 8:19 am
Re: Strip: Internal stem placement *PIC*
G New -- 9/29/2010, 8:14 pm
Re: Strip: Internal stem placement
Eric Anderson -- 9/30/2010, 10:16 am
Re: Strip: Internal stem placement
Allan -- 9/30/2010, 4:56 pm
Re: Strip: Internal stem placement
Eric Anderson -- 9/30/2010, 8:27 pm
Re: Strip: Internal stem placement
G New -- 9/30/2010, 10:51 pm
Re: Strip: Internal stem placement
Eric Anderson -- 10/3/2010, 9:08 am
Re: Strip: Internal stem placement
Bill Hamm -- 10/4/2010, 12:52 am
Re: Strip: Internal stem placement *PIC*
G New -- 10/3/2010, 5:21 pm
Re: Strip: Internal stem placement *PIC*
G New -- 10/3/2010, 5:18 pm
Re: Strip: Internal stem placement
G New -- 9/30/2010, 4:48 pm
Re: Strip: Internal stem placement *PIC*
Allan -- 9/29/2010, 5:00 pm
Re: Strip: Internal stem placement
Dean -- 9/29/2010, 9:17 am
Re: Strip: Internal stem placement *PIC*
Eric Anderson -- 9/29/2010, 10:25 am
Re: Strip: Internal stem placement
Ross Leidy -- 9/29/2010, 12:28 pm
Re: Strip: Internal stem placement
Eric Anderson -- 9/29/2010, 3:43 pm
Re: Strip: Internal stem placement
Bill Hamm -- 9/29/2010, 11:07 am
Re: Strip: Internal stem placement
Bill Hamm -- 9/29/2010, 11:09 am
Re: Strip: Internal stem placement
Bill Hamm -- 9/29/2010, 11:56 am
Re: Strip: Internal stem placement *PIC*
Eric Anderson -- 9/29/2010, 10:32 am
Re: Strip: Internal stem placement
Joe Whitman -- 9/29/2010, 12:17 pm
Re: Strip: Internal stem placement
Bill Hamm -- 9/29/2010, 11:14 am