Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: heat gun use
By:Bill Hamm
Date: 10/8/2010, 2:19 am
In Response To: heat gun use (sherm)

: Thanks Allan, just what I was looking for.

Btw, what you're doing is coaxing the strip into place if it won't go just bending it. Bend as far as it'll normally go, clamp it down, heat an area and push that closer to the bend and reclamp, gradually you'll get the whole strip into place.

Bill H.

Messages In This Thread

Strip: first strip
uga_danny -- 9/30/2010, 7:02 pm
Re: Strip: first strip *PIC*
danny -- 10/4/2010, 9:19 pm
Re: Strip: first strip
Bill Hamm -- 10/7/2010, 2:28 am
Re: Strip: first strip
sherm -- 10/7/2010, 2:10 pm
Re: Strip: first strip
Allan -- 10/7/2010, 4:32 pm
heat gun use
sherm -- 10/7/2010, 5:56 pm
Re: heat gun use
Bill Hamm -- 10/8/2010, 2:19 am
Re: heat gun use
Bill Hamm -- 10/8/2010, 2:17 am
Re: Strip: first strip
Paul G. Jacobson -- 10/1/2010, 6:23 am
Re: Strip: first strip
Bill Hamm -- 10/1/2010, 1:05 am