Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Material: Varnishing without drips *PIC*
By:Etienne Muller
Date: 11/29/2010, 3:13 pm
In Response To: Re: Material: Varnishing without drips (Gary Jacobson)

: Thanks Bill, I'm getting some feedback from everyone.
: -Gary

Use the roller. I use West rollers, and a decent brush for tipping off. If you tip off right you will have almost no varnish on the brush afterwards. Like Bill says, it goes fast and easy.

I suspend the boat, start at the front end and do the hull and deck in one go working backward in about eighteen or two foot rings.

I don't sand between coats. Jeese, I've done enough sanding by this stage.

Et

Messages In This Thread

Material: Varnishing without drips
Gary Jacobson -- 11/29/2010, 10:32 am
Re: Material: Varnishing without drips *PIC*
Dan Caouette (CSFW) -- 12/3/2010, 2:37 pm
Re: Material: Varnishing without drips
Eric -- 11/30/2010, 11:17 am
Re: Material: Varnishing without drips
Mike Bielski -- 11/29/2010, 6:26 pm
Re: Material: Varnishing without drips
Dave Houser -- 11/29/2010, 3:37 pm
Removing drips
Jay Babina -- 11/30/2010, 7:44 am
Re: Material: Varnishing without drips
Gary Jacobson -- 11/29/2010, 3:44 pm
Re: Material: Varnishing without drips
Bill Hamm -- 11/29/2010, 5:00 pm
Re: Material: Varnishing without drips
Bill Hamm -- 11/29/2010, 2:39 pm
Re: Material: Varnishing without drips
Gary Jacobson -- 11/29/2010, 2:49 pm
Re: Material: Varnishing without drips *PIC*
Etienne Muller -- 11/29/2010, 3:13 pm
Re: Material: Varnishing without drips
Bill Hamm -- 11/29/2010, 3:11 pm
Re: Material: Varnishing without drips *PIC*
Rob Macks / Laughing Loon CC&K -- 11/29/2010, 1:22 pm
Re: Material: Varnishing without drips
Rod Tait (Orca Boats) -- 11/29/2010, 6:13 pm
Re: Material: Varnishing without drips
Gary Jacobson -- 11/29/2010, 2:53 pm
Re: Material: Varnishing without drips
Rob Macks / Laughing Loon CC&K -- 11/29/2010, 4:05 pm
Re: Material: Varnishing without drips
Rob Macks------WebKitFormBoundarykHZ7kG4ZI7WSw+7N- -- 11/29/2010, 4:32 pm
Re: Material: Varnishing without drips
Jay Babina -- 11/29/2010, 10:55 am
Re: Material: Varnishing without drips
Gary Jacobson -- 11/29/2010, 11:11 am
Re: Material: Varnishing without drips
Jay Babina -- 11/29/2010, 11:23 am
Re: Material: Varnishing without drips
Etienne Muller -- 11/29/2010, 10:49 am
Re: Material: Varnishing without drips
Gary Jacobson -- 11/29/2010, 11:07 am