Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Strip: Cutting my own veneer
By:Todd O
Date: 11/29/2010, 11:48 pm

I need some veneer for external stems. Rather than ordering some, I was thinking about trying to cut my own. If I buy 1x material, cut it to 3/4 x 1 x length, could I just rip the 3/4 inch dimension to 1/16 at a time on the table saw? Any problems I'm not thinking of?

Messages In This Thread

Strip: Cutting my own veneer
Todd O -- 11/29/2010, 11:48 pm
Re: Strip: Cutting my own veneer
Glen Smith -- 11/30/2010, 6:29 pm
Re: Strip: Cutting my own veneer *PIC*
Todd O -- 12/1/2010, 6:12 pm
All under control now
Allan -- 12/1/2010, 6:27 pm
Re: Strip: Cutting my own veneer
Bill Hamm -- 11/30/2010, 12:49 am
Re: Strip: Cutting my own veneer
Todd O -- 11/30/2010, 10:34 am
Re: Strip: Cutting my own veneer
Bill Hamm -- 11/30/2010, 11:47 am
Re: Strip: Cutting my own veneer
Todd O -- 11/30/2010, 2:25 pm
Re: Strip: Cutting my own veneer
Bill Hamm -- 11/30/2010, 3:06 pm
Re: Strip: Cutting my own veneer
Bill Hamm -- 11/30/2010, 3:09 pm
Re: Strip: Cutting my own veneer
Todd O -- 11/30/2010, 5:17 pm
Re: Strip: Cutting my own veneer
Bill Hamm -- 12/1/2010, 1:31 am
Re: Strip: Cutting my own veneer
Allan -- 11/30/2010, 12:16 am
Re: Strip: Cutting my own veneer
Todd O -- 11/30/2010, 12:30 am
Re: Strip: Cutting my own veneer *PIC*
Allan -- 11/30/2010, 12:51 am
Re: Strip: Cutting my own veneer
Todd O -- 11/30/2010, 10:36 am
Re: Strip: Cutting my own veneer *PIC*
Allan -- 11/30/2010, 3:52 pm
Re: Strip: Cutting my own veneer
Todd O -- 11/30/2010, 5:19 pm