Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Strip: Cutting my own veneer
By:Todd O
Date: 11/30/2010, 2:25 pm
In Response To: Re: Strip: Cutting my own veneer (Bill Hamm)

: Radius shouldn't be that hard to bend a strip over, it will need
: heated to do it, but that's normal. Yes, you'll need to cut back
: the strips so the width is even or the stem will look awful.

: You can always alter the radius between the bottom and the bow,
: making the radius larger will make bending the strips easier.

: Bill H.

Hi Bill- Wouldn't altering the radius also change the width of the stem?

Messages In This Thread

Strip: Cutting my own veneer
Todd O -- 11/29/2010, 11:48 pm
Re: Strip: Cutting my own veneer
Glen Smith -- 11/30/2010, 6:29 pm
Re: Strip: Cutting my own veneer *PIC*
Todd O -- 12/1/2010, 6:12 pm
All under control now
Allan -- 12/1/2010, 6:27 pm
Re: Strip: Cutting my own veneer
Bill Hamm -- 11/30/2010, 12:49 am
Re: Strip: Cutting my own veneer
Todd O -- 11/30/2010, 10:34 am
Re: Strip: Cutting my own veneer
Bill Hamm -- 11/30/2010, 11:47 am
Re: Strip: Cutting my own veneer
Todd O -- 11/30/2010, 2:25 pm
Re: Strip: Cutting my own veneer
Bill Hamm -- 11/30/2010, 3:06 pm
Re: Strip: Cutting my own veneer
Bill Hamm -- 11/30/2010, 3:09 pm
Re: Strip: Cutting my own veneer
Todd O -- 11/30/2010, 5:17 pm
Re: Strip: Cutting my own veneer
Bill Hamm -- 12/1/2010, 1:31 am
Re: Strip: Cutting my own veneer
Allan -- 11/30/2010, 12:16 am
Re: Strip: Cutting my own veneer
Todd O -- 11/30/2010, 12:30 am
Re: Strip: Cutting my own veneer *PIC*
Allan -- 11/30/2010, 12:51 am
Re: Strip: Cutting my own veneer
Todd O -- 11/30/2010, 10:36 am
Re: Strip: Cutting my own veneer *PIC*
Allan -- 11/30/2010, 3:52 pm
Re: Strip: Cutting my own veneer
Todd O -- 11/30/2010, 5:19 pm