: Bill, in my quest to learn I have to ask a question. You seem to be
: saying one edge of the strips can be 5 degree beveled when
: ripping the strips. How is this possible?? When I make strips I
: rip 1/4" thick strips from a 3/4" thick board. To my
: understanding this would take 3 passes through the table saw -
: 1) to rip the 1/4" strip 2) bevel one edge 3) bevel the
: opposite edge. Not understanding how you rip the 1/4" strip
: and bevel one edge in a single pass????
: Thank you
When you're initially cutting the strips, instead of cutting them square to the board, angle the cut 3 degrees, you end up with parallelogram, then lay the strips down and cut the proper angle on the 2nd. side. The first strip cut will be waste, basically a very thin triangle, but each other strip cut will have a 3 degree angle on both ends, but one faces the wrong way.
Bill H.
Messages In This Thread
- Strip: Putting a 5 deg. bevel on strips
Stephen Troy -- 12/10/2010, 2:27 am- Re: Strip: Putting a 5 deg. bevel on strips
Rob Macks / Laughing Loon CC&K -- 12/10/2010, 8:45 am- Thanks Rob! *NM*
Stephen Troy -- 12/10/2010, 11:22 am- Re: Strip: Putting a 5 deg. bevel on strips
Bill Hamm -- 12/10/2010, 9:22 am- Re: Strip: Putting a 5 deg. bevel on strips
ancient kayaker -- 12/10/2010, 10:50 am- Re: Strip: Putting a 5 deg. bevel on strips
Bill Hamm -- 12/11/2010, 12:19 am- Re: Strip: Putting a 5 deg. bevel on strips
ancient kayaker -- 12/11/2010, 2:36 pm- Re: Strip: Putting a 5 deg. bevel on strips
Bill Hamm -- 12/12/2010, 12:46 am- Re: Strip: Putting a 5 deg. bevel on strips
Bill Hamm -- 12/12/2010, 12:47 am
- Re: Strip: Putting a 5 deg. bevel on strips
- Re: Strip: Putting a 5 deg. bevel on strips
- Re: Strip: Putting a 5 deg. bevel on strips
- Re: Strip: Putting a 5 deg. bevel on strips
- Re: Strip: Putting a 5 deg. bevel on strips
- Re: Strip: Putting a 5 deg. bevel on strips
Randy Echtinaw -- 12/10/2010, 5:03 am- Re: Strip: Putting a 5 deg. bevel on strips
Bill Hamm -- 12/10/2010, 8:19 am- Re: Strip: Putting a 5 deg. bevel on strips
Randy Echtinaw -- 12/10/2010, 9:40 am- Re: Strip: Putting a 5 deg. bevel on strips
Bill Hamm -- 12/10/2010, 2:43 pm- Re: Strip: Putting a 5 deg. bevel on strips
Jay Babina -- 12/10/2010, 10:42 am- Re: Strip: Putting a 5 deg. bevel on strips
Randy Echtinaw -- 12/10/2010, 11:01 am
- Re: Strip: Putting a 5 deg. bevel on strips
- Re: Strip: Putting a 5 deg. bevel on strips
- Re: Strip: Putting a 5 deg. bevel on strips
- Thanks Rob! *NM*
- Re: Strip: Putting a 5 deg. bevel on strips