Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Strip: Standard coming lip height and width?
By:Todd O
Date: 1/11/2011, 1:43 pm

Soon I'll be working on laminating a coming lip on my already existing coming riser. Is there a standard height (distance between top of deck and bottom of lip), and width (distance from outside of coming riser to outside of lip) to keep a spray skirt on well? Also; where do most get their wood for this? I've been searching for Ash Veneer, but it's all too thin, and often has paper on one side, etc. Is there someplace that sells like 1/8 inch ash veneer, or should I just plan on sawing my own?

Thanks,
Todd

Messages In This Thread

Strip: Standard coming lip height and width?
Todd O -- 1/11/2011, 1:43 pm
Re: Strip: Standard coming lip height and width? *PIC*
Joe Whitman -- 1/11/2011, 2:18 pm
Re: Strip: Standard coming lip height and width?
Joe Whitman -- 1/11/2011, 2:25 pm
Re: Strip: Standard coming lip height and width?
John Caldeira -- 1/11/2011, 2:24 pm
Re: Strip: Standard coming lip height and width?
Dave Houser -- 1/11/2011, 2:33 pm
Re: Strip: Standard coming lip height and width? *PIC*
Clayton Plunkett -- 1/11/2011, 2:58 pm
Re: Strip: Standard coming lip height and width? *PIC*
Ian Cummins -- 1/11/2011, 4:38 pm
Re: Strip: Standard coming lip height and width? *PIC*
Kurt Maurer -- 1/11/2011, 7:24 pm
Re: Strip: Standard coming lip height and width?
Bill Hamm -- 1/12/2011, 12:39 am
Re: Strip: Standard coming lip height and width? *PIC*
Etienne Muller - ireland -- 1/12/2011, 8:29 am
Re: Strip: Standard coming lip height and width? *NM* *PIC*
Etienne Muller - ireland -- 1/12/2011, 8:30 am
Re: Strip: Standard coming lip height and width? *NM* *PIC*
Etienne Muller - ireland -- 1/12/2011, 8:31 am
Re: Strip: Standard coming lip height and width?
Todd O -- 1/12/2011, 10:00 am
Re: Strip: Standard coming lip height and width? *PIC*
Etienne Muller - ireland -- 1/13/2011, 7:13 am
Re: Strip: Standard coming lip height and width? *PIC*
Etienne Muller - ireland -- 1/13/2011, 7:16 am
Re: Strip: Standard coming lip height and width?
Bill Hamm -- 1/13/2011, 8:59 am