Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: S&G: 90 degree corners
By:dave g
Date: 2/6/2011, 8:16 pm
In Response To: Re: S&G: 90 degree corners (Bill Hamm)

: Hi Dave,

: Every time I've tried this it leaked. There is so little bonding
: area between the two edges that if it's not absolutely perfect,
: water seeps in at the joint.

: Bill H.

Fair enough I use this technique when replaceing a transom on an outboard boat for the top edge that the motor sits on but in that case there is a lot more glass to tie into.

dave g

Messages In This Thread

S&G: 90 degree corners
Randy Knauff -- 2/6/2011, 1:16 pm
Re: S&G: 90 degree corners
Bill Hamm -- 2/6/2011, 1:58 pm
Re: S&G: 90 degree corners
Bill Hamm -- 2/6/2011, 2:03 pm
Re: S&G: 90 degree corners *PIC*
Paul G. Jacobson -- 2/7/2011, 5:39 am
Re: S&G: 90 degree corners
John Caldeira -- 2/7/2011, 10:24 am
Re: S&G: 90 degree corners *PIC*
Paul G. Jacobson -- 2/7/2011, 10:46 pm
Re: S&G: 90 degree corners
Bill Hamm -- 2/8/2011, 12:29 am
Re: S&G: 90 degree corners
dave g -- 2/6/2011, 2:18 pm
Re: S&G: 90 degree corners
Bill Hamm -- 2/6/2011, 3:58 pm
Re: S&G: 90 degree corners
dave g -- 2/6/2011, 8:16 pm
Re: S&G: 90 degree corners
Bill Hamm -- 2/7/2011, 12:08 am
Re: S&G: 90 degree corners
Wesley Ewell -- 2/6/2011, 4:38 pm
Re: S&G: 90 degree corners
Al Edie -- 2/6/2011, 10:17 pm
thanks for many good ideas
Randy Knauff -- 2/8/2011, 11:19 am
Re: S&G: 90 degree corners
John Caldeira -- 2/6/2011, 10:46 pm
Re: S&G: 90 degree corners
Bill Hamm -- 2/7/2011, 12:14 am
Re: S&G: 90 degree corners
mick allen -- 2/7/2011, 1:04 am
Re: S&G: 90 degree corners
Eric -- 2/7/2011, 1:51 pm