Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: S&G: 90 degree corners
By:John Caldeira
Date: 2/7/2011, 10:24 am
In Response To: Re: S&G: 90 degree corners *PIC* (Paul G. Jacobson)

: Good idea and there is an easy method. Once the radiused
: hull-to-bulkhead seam is glassed you build up an oversized
: square edge from thickened or filled resin, ....

I like your idea of building up a sharp edge ON TOP of the rounded, fiberglassed 90 degree joint. Clever, and obvious in hindsight. Not sure it needs to be overengineered beyond that.

John

Messages In This Thread

S&G: 90 degree corners
Randy Knauff -- 2/6/2011, 1:16 pm
Re: S&G: 90 degree corners
Bill Hamm -- 2/6/2011, 1:58 pm
Re: S&G: 90 degree corners
Bill Hamm -- 2/6/2011, 2:03 pm
Re: S&G: 90 degree corners *PIC*
Paul G. Jacobson -- 2/7/2011, 5:39 am
Re: S&G: 90 degree corners
John Caldeira -- 2/7/2011, 10:24 am
Re: S&G: 90 degree corners *PIC*
Paul G. Jacobson -- 2/7/2011, 10:46 pm
Re: S&G: 90 degree corners
Bill Hamm -- 2/8/2011, 12:29 am
Re: S&G: 90 degree corners
dave g -- 2/6/2011, 2:18 pm
Re: S&G: 90 degree corners
Bill Hamm -- 2/6/2011, 3:58 pm
Re: S&G: 90 degree corners
dave g -- 2/6/2011, 8:16 pm
Re: S&G: 90 degree corners
Bill Hamm -- 2/7/2011, 12:08 am
Re: S&G: 90 degree corners
Wesley Ewell -- 2/6/2011, 4:38 pm
Re: S&G: 90 degree corners
Al Edie -- 2/6/2011, 10:17 pm
thanks for many good ideas
Randy Knauff -- 2/8/2011, 11:19 am
Re: S&G: 90 degree corners
John Caldeira -- 2/6/2011, 10:46 pm
Re: S&G: 90 degree corners
Bill Hamm -- 2/7/2011, 12:14 am
Re: S&G: 90 degree corners
mick allen -- 2/7/2011, 1:04 am
Re: S&G: 90 degree corners
Eric -- 2/7/2011, 1:51 pm