Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Shop: You don't need a big workshop
By:Bill Hamm
Date: 2/17/2011, 12:58 pm
In Response To: Re: Shop: You don't need a big workshop (Robert N Pruden)

: My weight guide is the waist of my pants. If they go on and aren't
: too tight, I keep eating. If they start getting tight (after a
: day of use), then I avoid certain meals (the junk food kind). I
: have been the same size for decades and hope to keep it that
: way. I noticed that with our recent warm weather spell (since
: ended, Brrrrrr!) the river ice has started to recede, could be
: an early paddling season. I figure that I have two full months
: left to get Linda's kayak done before I stop building and get
: the old VJ on the float again. :) For now, I am heading off to
: Winterpeg, Manitoba to ski with the boys while dragging all of
: my gear behind me on the modified komatik I built. I will post a
: pic of the final look of the komatik later on today.

: Robert N(o Esquimo) Pruden

Snow's gone here for now, supposed to be near 60 degrees today, might set a new record. Last week same day it was 13 below zero. Weird weather.

Bill H.

Messages In This Thread

Shop: You don't need a big workshop
Malcolm Schweizer -- 2/14/2011, 10:23 pm
Re: Shop: You don't need a big workshop
Farback -- 2/14/2011, 11:01 pm
Re: Shop: You don't need a big workshop
Matt Brammer -- 2/14/2011, 11:15 pm
Re: Shop: You don't need a big workshop *PIC*
Malcolm Schweizer -- 2/14/2011, 11:57 pm
Re: Shop: You don't need a big workshop
Bill Hamm -- 2/15/2011, 1:43 am
clarification- not a pilot hole, a vent hole.
Malcolm Schweizer -- 2/14/2011, 11:22 pm
Re: clarification- not a pilot hole, a vent hole.
Bill Hamm -- 2/15/2011, 1:50 am
Re: Shop: You don't need a big workshop
Bill Hamm -- 2/15/2011, 1:41 am
Re: Shop: You don't need a big workshop
Robert N Pruden -- 2/15/2011, 9:50 am
Re: Shop: You don't need a big workshop
Bill Hamm -- 2/16/2011, 12:39 am
Re: Shop: You don't need a big workshop
Robert N Pruden -- 2/16/2011, 9:33 am
Re: Shop: You don't need a big workshop
Bill Hamm -- 2/17/2011, 1:33 am
Re: Shop: You don't need a big workshop
Robert N Pruden -- 2/17/2011, 8:52 am
Re: Shop: You don't need a big workshop
Bill Hamm -- 2/17/2011, 12:58 pm
Re: Shop: You don't need a big workshop
Robert N Pruden -- 2/17/2011, 1:20 pm
Re: Shop: You don't need a big workshop
Bill Hamm -- 2/17/2011, 1:33 pm
Re: Shop: You don't need a big workshop
Robert N Pruden -- 2/17/2011, 1:57 pm
Re: Shop: You don't need a big workshop
Bill Hamm -- 2/17/2011, 2:55 pm
Re: Shop: You don't need a big workshop
Mike Savage -- 2/15/2011, 4:46 am
Re: Shop: You don't need a big workshop
Bill Hamm -- 2/16/2011, 12:41 am
Re: Shop: You don't need a big workshop
John Roberts -- 2/15/2011, 7:51 pm
Re: Shop: You don't need a big workshop
Etienne Muller - ireland -- 2/16/2011, 6:35 am
Re: Shop: You don't need a big workshop
Robert N Pruden -- 2/16/2011, 11:59 am
Re: Shop: You don't need a big workshop
Fred Gasper -- 2/16/2011, 1:10 pm
Re: Shop: You don't need a big workshop
Malcolm Schweizer -- 2/16/2011, 11:15 pm
Re: Shop: You don't need a big workshop
Bill Hamm -- 2/17/2011, 1:36 am
Re: Shop: You don't need a big workshop
Etienne Muller - ireland -- 2/17/2011, 4:53 pm
Re: Shop: You don't need a big workshop
Malcolm Schweizer -- 2/16/2011, 11:12 pm
Re: Shop: You don't need a big workshop
Bill Hamm -- 2/17/2011, 1:39 am
Re: Shop: You do need a system
ancient kayaker -- 2/17/2011, 6:02 pm
Re: Shop: You do need a system
Bill Hamm -- 2/17/2011, 7:10 pm
Re: Shop: You don't need a big workshop
Bill Hamm -- 2/17/2011, 1:34 am
Re: Shop: You don't need a big workshop
Scott Baxter -- 2/20/2011, 7:28 pm