Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Strip: Cutting Cloth to conform
By:Jim Schaffer
Date: 2/26/2011, 12:18 pm
In Response To: Re: Strip: Cutting Cloth to conform (Tony Olsen)

I've never done this before but I wonder if the tight weave of the 3.2 cloth from Thayercraft isn't helping it to conform. The boat designer says cloth should conform without cutting.
The second layer is going on soon. I guess I'll cut that too but it seems once I start cutting there's no end before I get a good, clean overlap.
I'll use two abrasion layers, cut on a diagonal, once the next full layer is on?

Thanks, Jim

Messages In This Thread

Strip: Cutting Cloth to conform *PIC*
Jim Schaffer -- 2/26/2011, 11:19 am
Re: Strip: Cutting Cloth to conform
Tony Olsen -- 2/26/2011, 11:55 am
Re: Strip: Cutting Cloth to conform
Jim Schaffer -- 2/26/2011, 12:18 pm
Re: Strip: Cutting Cloth to conform *PIC*
dave g -- 2/26/2011, 5:05 pm
Re: Strip: Cutting Cloth to conform
dave g -- 2/26/2011, 8:48 pm
Re: Strip: Cutting Cloth to conform
dhwdaniels -- 3/5/2011, 8:13 am
Re: Strip: Cutting Cloth to conform
dave g -- 3/5/2011, 10:05 am
Re: Strip: Cutting Cloth to conform
Bill Hamm -- 3/6/2011, 1:09 am
Re: Strip: excess cloth
Paul G. Jacobson -- 3/6/2011, 11:30 am
Re: Strip: excess cloth
Bill Hamm -- 3/6/2011, 4:57 pm
Re: Strip: Cutting Cloth to conform
Ian Johnson -- 2/26/2011, 5:16 pm
Re: Strip: Cutting Cloth to conform
Paul G. Jacobson -- 2/26/2011, 6:42 pm
Re: Strip: Cutting Cloth to conform *PIC*
Jim Schaffer -- 2/27/2011, 9:07 am
Re: Strip: Cutting Cloth to conform
dave g -- 2/27/2011, 12:33 pm
Re: Strip: Cutting Cloth to conform *PIC*
Jim Schaffer -- 2/27/2011, 4:57 pm
Re: Strip: Cutting Cloth to conform
JohnK -- 2/26/2011, 4:02 pm
Re: Strip: Cutting Cloth to conform
Bill Hamm -- 2/27/2011, 12:14 am
Re: Strip: Cutting Cloth to conform
Erik Jensen -- 2/27/2011, 8:40 pm