Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Strip: Cutting Cloth to conform
By:dave g
Date: 2/26/2011, 8:48 pm
In Response To: Re: Strip: Cutting Cloth to conform *PIC* (dave g)

: Hi Jim, I also used the 3.2 from thayercraft and had no problem
: with getting it to conform to the end of the boat except the
: very tip. All I did was use a spring clamp on the end to help
: drag it down so it was tight. If the end doesn't want to stay
: tight to the boat I just taped the spring clamp to the stand
: holding the boat.

: dave g

i should say that I did drape the cloth on the boat on the bias ( corner of the roll to opposite corner of the roll tip to tip)

dave g

Messages In This Thread

Strip: Cutting Cloth to conform *PIC*
Jim Schaffer -- 2/26/2011, 11:19 am
Re: Strip: Cutting Cloth to conform
Tony Olsen -- 2/26/2011, 11:55 am
Re: Strip: Cutting Cloth to conform
Jim Schaffer -- 2/26/2011, 12:18 pm
Re: Strip: Cutting Cloth to conform *PIC*
dave g -- 2/26/2011, 5:05 pm
Re: Strip: Cutting Cloth to conform
dave g -- 2/26/2011, 8:48 pm
Re: Strip: Cutting Cloth to conform
dhwdaniels -- 3/5/2011, 8:13 am
Re: Strip: Cutting Cloth to conform
dave g -- 3/5/2011, 10:05 am
Re: Strip: Cutting Cloth to conform
Bill Hamm -- 3/6/2011, 1:09 am
Re: Strip: excess cloth
Paul G. Jacobson -- 3/6/2011, 11:30 am
Re: Strip: excess cloth
Bill Hamm -- 3/6/2011, 4:57 pm
Re: Strip: Cutting Cloth to conform
Ian Johnson -- 2/26/2011, 5:16 pm
Re: Strip: Cutting Cloth to conform
Paul G. Jacobson -- 2/26/2011, 6:42 pm
Re: Strip: Cutting Cloth to conform *PIC*
Jim Schaffer -- 2/27/2011, 9:07 am
Re: Strip: Cutting Cloth to conform
dave g -- 2/27/2011, 12:33 pm
Re: Strip: Cutting Cloth to conform *PIC*
Jim Schaffer -- 2/27/2011, 4:57 pm
Re: Strip: Cutting Cloth to conform
JohnK -- 2/26/2011, 4:02 pm
Re: Strip: Cutting Cloth to conform
Bill Hamm -- 2/27/2011, 12:14 am
Re: Strip: Cutting Cloth to conform
Erik Jensen -- 2/27/2011, 8:40 pm