Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Strip: Cutting Cloth to conform
By:Bill Hamm
Date: 2/27/2011, 12:14 am
In Response To: Strip: Cutting Cloth to conform *PIC* (Jim Schaffer)

: Hi guys,
: Just finished wetting out first layer of 3.2 on my Cape Ann and
: cloth did not conform to bow and stern at all. Any advice on how
: to cut the cloth at these areas without making a mess like I
: just did?
: Hopefully the next layer will be more successful.

: Btw, thanks for the forum's advice thus far. 3.2 + MAS in a 65
: degree cellar and I haven't swore once...

Put the cloth on at a bias, from corner to opposite corner of the cloth with the boat sitting diagonally across the cloth, will conform much easier that way.

Bill H.

Messages In This Thread

Strip: Cutting Cloth to conform *PIC*
Jim Schaffer -- 2/26/2011, 11:19 am
Re: Strip: Cutting Cloth to conform
Tony Olsen -- 2/26/2011, 11:55 am
Re: Strip: Cutting Cloth to conform
Jim Schaffer -- 2/26/2011, 12:18 pm
Re: Strip: Cutting Cloth to conform *PIC*
dave g -- 2/26/2011, 5:05 pm
Re: Strip: Cutting Cloth to conform
dave g -- 2/26/2011, 8:48 pm
Re: Strip: Cutting Cloth to conform
dhwdaniels -- 3/5/2011, 8:13 am
Re: Strip: Cutting Cloth to conform
dave g -- 3/5/2011, 10:05 am
Re: Strip: Cutting Cloth to conform
Bill Hamm -- 3/6/2011, 1:09 am
Re: Strip: excess cloth
Paul G. Jacobson -- 3/6/2011, 11:30 am
Re: Strip: excess cloth
Bill Hamm -- 3/6/2011, 4:57 pm
Re: Strip: Cutting Cloth to conform
Ian Johnson -- 2/26/2011, 5:16 pm
Re: Strip: Cutting Cloth to conform
Paul G. Jacobson -- 2/26/2011, 6:42 pm
Re: Strip: Cutting Cloth to conform *PIC*
Jim Schaffer -- 2/27/2011, 9:07 am
Re: Strip: Cutting Cloth to conform
dave g -- 2/27/2011, 12:33 pm
Re: Strip: Cutting Cloth to conform *PIC*
Jim Schaffer -- 2/27/2011, 4:57 pm
Re: Strip: Cutting Cloth to conform
JohnK -- 2/26/2011, 4:02 pm
Re: Strip: Cutting Cloth to conform
Bill Hamm -- 2/27/2011, 12:14 am
Re: Strip: Cutting Cloth to conform
Erik Jensen -- 2/27/2011, 8:40 pm