Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Skin-on-Frame: What's the best sanding method
By:Eric
Date: 3/16/2011, 7:44 pm
In Response To: Skin-on-Frame: What's the best sanding method (Todd Olson)

I use a small collection of sanding spindles on my drill press. It isn't quite as effective as the spindle sander, but it is less expensive than owning two tools.

Eric

Messages In This Thread

Skin-on-Frame: What's the best sanding method
Todd Olson -- 3/14/2011, 7:35 pm
Re: Skin-on-Frame: What's the best sanding method
Dave Gentry -- 3/14/2011, 7:54 pm
Re: Skin-on-Frame: What's the best sanding method
Todd Olson -- 3/14/2011, 8:08 pm
Re: Skin-on-Frame: What's the best sanding method *PIC*
Paul G. Jacobson -- 3/15/2011, 2:42 am
Re: Skin-on-Frame: What's the best sanding method
Paul R -- 3/14/2011, 10:54 pm
Re: Skin-on-Frame: What's the best sanding method
Bill Hamm -- 3/15/2011, 12:51 am
Re: Skin-on-Frame: What's the best sanding method
Bill Hamm -- 3/15/2011, 12:52 am
Re: Skin-on-Frame: What's the best sanding method
Brian Nystrom -- 3/15/2011, 7:01 am
Re: Skin-on-Frame: What's the best sanding method
ancient kayaker -- 3/15/2011, 7:10 pm
Re: Skin-on-Frame: What's the best sanding method
Brian Nystrom -- 3/16/2011, 6:42 am
10 inch sanding disk *PIC*
Paul G. Jacobson -- 3/15/2011, 7:12 pm
Re: 10 inch sanding disk
Bill Hamm -- 3/16/2011, 12:32 am
Re: 10 inch sanding disk
Brian Nystrom -- 3/16/2011, 6:47 am
Re: 10 inch sanding disk
ancient kayaker -- 3/16/2011, 10:21 am
Re: 10 inch sanding disk
Bill Hamm -- 3/17/2011, 12:20 am
Re: Skin-on-Frame: What's the best sanding method
Eric -- 3/16/2011, 7:44 pm
Re: Skin-on-Frame: What's the best sanding method
Bill Hamm -- 3/17/2011, 12:22 am
spindle sanding method
Paul G. Jacobson -- 3/17/2011, 5:28 am
Re: spindle sanding method
Bill Hamm -- 3/17/2011, 6:57 am
Re: spindle sanding method
Eric -- 3/17/2011, 3:19 pm
Re: Skin-on-Frame: What's the best sanding method
Jay Babina -- 3/17/2011, 8:51 am
Re: Skin-on-Frame: What's the best sanding method
eric Ogata -- 3/17/2011, 10:59 am