Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Strip: coaming lip
By:jwuts
Date: 3/21/2011, 6:27 pm

I am building a Return but making the coaming lip like Nicks book says to with small vertical peices set into the cockpit cut out. I am using walnut and have cut peices 1/6 by 3/8+ The trouble is not bending the peices around the vertical peices but keeping them and even distance from the deck. They need to bend two ways which is not working out so well. They start to pull away from the vertical pieces alot. Even doing them one at a time does not seam to help. Has anyone run into this problem and have any suggestions. Thanks Joe

Messages In This Thread

Strip: coaming lip
jwuts -- 3/21/2011, 6:27 pm
Re: Strip: coaming lip *PIC*
Ian Cummins -- 3/21/2011, 8:26 pm
Re: Strip: coaming lip *PIC*
Todd O -- 3/21/2011, 10:51 pm
Re: Strip: coaming lip *PIC*
Todd O -- 3/21/2011, 11:03 pm
Re: Strip: coaming lip *PIC*
Todd O -- 3/21/2011, 11:04 pm
Re: Strip: coaming lip *PIC*
Brian Nystrom -- 3/22/2011, 6:37 am
Re: Strip: coaming lip
Mike Bielski -- 3/22/2011, 8:13 am
Re: Strip: coaming lip
Brian Nystrom -- 3/22/2011, 11:15 pm
Re: Strip: coaming lip
Bill Hamm -- 3/23/2011, 1:39 am
Re: Strip: coaming lip *PIC*
Brian Nystrom -- 3/23/2011, 6:51 am
Re: Strip: coaming lip
Bill Hamm -- 3/23/2011, 1:51 pm
Re: Strip: coaming lip
Randy Echtinaw -- 3/22/2011, 10:10 am
Re: Strip: coaming lip
Joe Whitman -- 3/22/2011, 12:00 pm
Re: Strip: coaming lip
Ric Moodie -- 3/22/2011, 3:02 pm
Re: Strip: coaming lip
jwuts -- 3/22/2011, 4:50 pm
Re: Strip: coaming lip
Mike Savage -- 3/22/2011, 6:33 pm
Re: Strip: coaming lip *PIC*
Don T -- 3/22/2011, 10:24 pm
Re: Strip: coaming lip
Ric Moodie -- 3/23/2011, 3:32 pm