: Hey guys,
: Today I fevereshly lashed/glued all my offsets checking level on
: gunwales (side to side) andvertically (top to bottom). Did all
: and
: failed to realize #4 (of 6 in a seatour) was glued/lashed at an
: angle (strboard side is close to 1/4" fwd of the
: portside (or viceversa). Aaanyway, what to do?
: A. Heat gun the titebond 3 and redo?
: B. Cut it out and make the offset anew leaving all others
: untouched?
: C. Leave it and see what happens w/ performance?

: Thanks for ANY advice... I was thinking c cause I am out of budget
: but it bugs me!!!

I find that anything I build has something I think I should have done better. That's how it goes.
The important thing is the outside shape of the kayak (and in particular, the underwater part), not the internal structure, so I would check the symmetry of your gunwales. If they are the same or close, you're good, just leave it as is. Actually for a 1/4 in shift longitudinally, I would be surprised if there is much if any effect on the outside shape.
Mark