I got my cedar cut down into 3/16 thick strips today. I have a question though. Most of the time when you by wood advertised as 1x whatever, the 1" is usually a bit less than 1". In my case it was more, 1 and 1.16" to be exact.

I realize that I will lose some to milling the B&C on them, but I am seriously wondering if I should split the strips I have into 1/2" strips prior to milling the B&C. It seems like it would be a lot easier to mold the bow and stern. The 1" width seems REALLY wide, even with a heat gun. I know it would be more work, but I really don't mind.

Thoughts or suggestions on this?