Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Strip: inner stem placement
By:les cheeseman
Date: 12/15/2011, 10:52 am
In Response To: Re: Strip: inner stem placement (Bill Hamm)

: For the inner stem I don't bend it, I cut it from a wider piece.
: Depending on the curve required I'll glue up a wider piece if
: necessary, allows you to keep the grain running in the correct
: direction too. No chance of springback with an unbent inner
: stem.

: Outer stems I bend in place.

Likewise Bill. I cut a sickle shaped slice off of the leading/trailing edge
of the stems, and use that as a pattern for a WRC block 3/4" thick which
I hot glue into position before fairing the edge to a point, using a pair of
strips pulled around a fair curve on the stations, to give me the bevel angle.

Les C.

Messages In This Thread

Strip: inner stem placement
Douglas Lee -- 12/13/2011, 2:36 pm
Re: Strip: inner stem placement
Allan -- 12/13/2011, 2:50 pm
Re: Strip: inner stem placement
Douglas Lee -- 12/13/2011, 5:57 pm
Re: Strip: inner stem placement
Todd Olson -- 12/13/2011, 6:06 pm
Re: Strip: inner stem placement
Douglas Lee -- 12/13/2011, 6:29 pm
Re: Strip: inner stem placement
Bill Hamm -- 12/14/2011, 2:18 am
Re: Strip: inner stem placement
Douglas Lee -- 12/14/2011, 11:28 am
Re: Strip: inner stem placement
Don T -- 12/14/2011, 1:25 pm
Re: Strip: inner stem placement
ancient kayaker -- 12/14/2011, 3:43 pm
Re: Strip: inner stem placement
Bill Hamm -- 12/15/2011, 2:37 am
Re: Strip: inner stem placement
les cheeseman -- 12/15/2011, 10:52 am
Re: Strip: inner stem placement
Bill Hamm -- 12/15/2011, 2:34 am
Re: Strip: inner stem placement
Bryan Hansel -- 12/13/2011, 6:12 pm
Re: Strip: inner stem placement
Dan Caouette (CSFW) -- 12/13/2011, 6:24 pm
Re: Strip: inner stem placement
Douglas Lee -- 12/13/2011, 6:33 pm
Re: Strip: inner stem placement
Ian Cummins -- 12/13/2011, 6:37 pm
Re: Strip: inner stem placement
Douglas Lee -- 12/13/2011, 7:59 pm
Re: Strip: inner stem placement
Douglas Lee -- 12/14/2011, 5:58 pm