Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Strip: Joining deck and hull question
By:Etienne Muller
Date: 2/26/2012, 5:45 am
In Response To: Re: Strip: Joining deck and hull question *PIC* (Etienne Muller)

I should perhaps have mentioned that in the above picture the bulkheads are already in place, filleted into the hull and sanded, ready for filleting, at the deck. I get to that through the hatches etc afterwards.

Et

Messages In This Thread

Strip: Joining deck and hull question
righty22 -- 2/25/2012, 7:52 pm
Re: Strip: Joining deck and hull question
Pedro Almeida -- 2/25/2012, 9:45 pm
Re: Strip: Joining deck and hull question
righty22 -- 2/25/2012, 9:48 pm
Re: Strip: Joining deck and hull question
Pedro Almeida -- 2/25/2012, 10:11 pm
Re: Strip: Joining deck and hull question
Jay Babina -- 2/26/2012, 8:09 am
Correction...
Jay Babina -- 2/26/2012, 9:12 am
Re: Strip: Joining deck and hull question
Nick Riccardi -- 2/26/2012, 11:52 am
Re: Strip: Joining deck and hull question
Allan -- 2/26/2012, 3:25 pm
Re: Strip: Joining deck and hull question *PIC*
Etienne Muller -- 2/26/2012, 5:43 am
Re: Strip: Joining deck and hull question
Etienne Muller -- 2/26/2012, 5:45 am
Re: Strip: Joining deck and hull question
Randy Echtinaw -- 2/26/2012, 9:31 am
Re: Strip: Joining deck and hull question *PIC*
Yostwerks -- 2/26/2012, 10:49 am
Re: Strip: Joining deck and hull question
Etienne Muller -- 2/26/2012, 1:07 pm
Re: Strip: Joining deck and hull question
Randy Echtinaw -- 2/26/2012, 3:12 pm