Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Strip: Rabbit Plane
By:ancient kayaker
Date: 4/17/2012, 4:26 pm
In Response To: Re: Strip: Rabbit Plane (Dave Houser)

: Typical cutting blade angle for planes is 45 degrees to the surface
: with the bevel down. Try rotating the chisel 180 degrees to what
: is shown in your picture.

: Bevel up blades are typical in low angle planes. Which would make
: it difficult to hold the blade with a wedge.

- Oops! It IS meant to be bevel down! I just slapped it together for the photo op . . . well spotted; Hawkeye award of the month!

Messages In This Thread

Strip: Rabbit Plane
Mike -- 4/15/2012, 8:55 pm
Re: Strip: Rabbit Plane
Paul Davies -- 4/15/2012, 9:19 pm
Re: Strip: Rabbit Plane *PIC*
Malcolm Schweizer -- 4/16/2012, 5:25 pm
Re: Strip: Rabbit Plane *PIC*
ancient kayaker -- 4/16/2012, 8:25 pm
Re: Strip: Rabbit Plane
Mike -- 4/16/2012, 10:04 pm
Re: Strip: Rabbit Plane
ancient kayaker -- 4/17/2012, 10:05 am
Re: Strip: Rabbit Plane
Dave Houser -- 4/17/2012, 3:37 pm
Re: Strip: Rabbit Plane
ancient kayaker -- 4/17/2012, 4:26 pm
Re: Strip: Rabbit Plane *PIC*
Will N To Go -- 4/17/2012, 6:54 pm
Re: Strip: Rabbit Plane *PIC*
Etienne Muller -- 4/18/2012, 5:03 am
Re: Strip: Rabbit Plane
Randy Echtinaw -- 4/18/2012, 7:41 am
Re: Strip: Rabbit Plane
Mark Vander Horck -- 4/20/2012, 5:29 pm
Re: Strip: Rabbit Plane
Randy Echtinaw -- 4/21/2012, 7:06 pm
Re: Strip: Rabbit Plane
Mark Vander Horck -- 4/23/2012, 11:46 am
Re: Strip: Rabbit Plane
Paul Davies -- 4/18/2012, 2:18 pm
Re: Strip: Rabbit Plane
Mike -- 4/19/2012, 6:45 pm
Re: Strip: Rabbit Plane
ancient kayaker -- 4/19/2012, 7:01 pm
Re: Strip: Rabbit Plane
Mike -- 4/19/2012, 8:00 pm