: Hello,
: I have a Veritas router table with a Porter Cable router (no micro
: adjustment), I dedicated this for bead cutting and locked it in.
: Just assembled a Bosch table router using again another Porter
: Cable with no micro adjustment. dedicating this one for coves.
: I tried every which way to tandem cut the strips but can not set it
: up so that the bit will cut counter clockwise into the strip
: for the bead and cove. One bit will cut counter clockwise but the
: other cuts clockwise into the strip.
: How do you all set them up to cut counter clockwise to the feed
: direction on both bead and cove?

: Thanks,
: Douglas

I don't think there is a way unless you can suspend one of the routers upside-down. It might be best to stagger the routers to allow strip width to be fine-tuned by canting the fence. Another solution - if you have arbor-mounted bits - would be to stack the bits on a common arbor and run the strips through in pairs, then flip and run the other edge. Only way I can think of to save time but it doesn't deliver the strip width control you probably want. . .