Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Strip: to glass or not to glass
By:Ric Moodie
Date: 7/21/2012, 9:49 pm
In Response To: Strip: to glass or not to glass (Andrew T)

Rather than say you should or shouldn't do it I'll just say that it is not that hard to glass your coaming lip. If you find it is not going well you can just pull everything off before the epoxy sets, wipe it clean and start over. I put thin plastic film on top of the wet epoxy and glass and then slit open a bicycle tube and wrapped it tightly around the perimeter of the coaming. After the epoxy set and I pulled off the tube and film there where just a few thin ridges of epoxy to sand off. Things get a bit slippery putting on the tube but it can be done or done again if the first try goes wrong.

Ric

Messages In This Thread

Strip: to glass or not to glass
Andrew T -- 7/21/2012, 12:03 pm
Re: Strip: to glass or not to glass
scottbaxter -- 7/21/2012, 2:20 pm
Re: Strip: to glass or not to glass
John Abercrombie -- 7/21/2012, 5:09 pm
Re: Strip: to glass or not to glass
JohnFaas -- 7/22/2012, 12:19 pm
Re: Strip: to glass or not to glass
Nick Riccardi -- 7/21/2012, 3:14 pm
Re: Strip: to glass or not to glass
Rod Tait (Orca Boats) -- 7/21/2012, 5:03 pm
Re: Strip: to glass or not to glass
John Abercrombie -- 7/21/2012, 9:47 pm
Re: Strip: to glass or not to glass
Rod Tait (Orca Boats) -- 7/21/2012, 10:00 pm
Re: Strip: to glass or not to glass
Mike Savage -- 7/22/2012, 9:41 am
Re: Strip: to glass or not to glass
ancient kayaker -- 7/22/2012, 10:05 pm
Re: Strip: to glass or not to glass
John Abercrombie -- 7/23/2012, 3:00 am
Re: Strip: to glass or not to glass
Brian Hanks -- 7/23/2012, 5:43 am
Re: Strip: to glass or not to glass
dave g -- 7/23/2012, 9:22 pm
Re: Strip: to glass or not to glass
Brian Hanks -- 7/24/2012, 5:58 am
Re: Strip: to glass or not to glass
dave g -- 7/24/2012, 8:58 pm
Re: Strip: to glass or not to glass
Bill Hamm -- 7/25/2012, 2:02 am
Re: Strip: to glass or not to glass
Bill Hamm -- 7/24/2012, 1:39 am
Re: Strip: to glass or not to glass
Brian Hanks -- 7/24/2012, 5:56 am
Re: Strip: to glass or not to glass
Bill Hamm -- 7/25/2012, 2:04 am
Re: Strip: to glass or not to glass
Brian Hanks -- 7/26/2012, 10:30 pm
Re: Strip: to glass or not to glass
Bill Hamm -- 7/26/2012, 10:50 pm
Re: Strip: to glass or not to glass
Bill Hamm -- 7/22/2012, 12:44 am
Re: Strip: to glass or not to glass
Rod Tait (Orca Boats) -- 7/22/2012, 10:43 am
Re: Strip: to glass or not to glass
Ric Moodie -- 7/21/2012, 9:49 pm
Needed vs. necessary
Jay Babina -- 7/22/2012, 7:58 am