Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Paddle: Ply for blades?
By:ancient kayaker
Date: 8/5/2012, 10:23 pm
In Response To: Re: Paddle: Ply for blades? (Brian Nystrom)

: I can think of a couple of reasons:

: 1- You can only bend it in one plane and unless you're using thin
: ply, you may not be able to bend it much.
: 2- You can't sand the surface to shape, since you'd cut through the
: plies and it would look terrible.

: There's no reason that it couldn't be used for very simple blade
: designs as long you seal the edges well, but you can't do much
: with it.

Gotcha. Thanks!

Messages In This Thread

Paddle: Ply for blades?
ancient kayaker -- 8/5/2012, 2:43 pm
Re: Paddle: Ply for blades?
Brian Nystrom -- 8/5/2012, 7:07 pm
Re: Paddle: Ply for blades?
ancient kayaker -- 8/5/2012, 10:23 pm
Re: Paddle: Ply for blades?
Ray Golden -- 8/6/2012, 2:11 am
It appears your site has been hacked...
Brian Nystrom -- 8/6/2012, 6:05 am
It's complaining about your Facebook page, too
Brian Nystrom -- 8/6/2012, 6:10 am
Re: It's complaining about your Facebook page, too
Ray Golden -- 8/6/2012, 8:13 am
Re: Paddle: Ply for blades? *PIC*
Yostwerks -- 8/6/2012, 9:28 am
Re: Paddle: Ply for blades?
Bill Hamm -- 8/7/2012, 1:28 am
Re: Paddle: Ply for blades?
Yostwerks -- 8/7/2012, 8:47 am
Re: Paddle: Ply for blades?
ancient kayaker -- 8/7/2012, 9:10 am
Re: Paddle: Ply for blades?
Bill Hamm -- 8/8/2012, 12:26 am
Re: Paddle: Ply for blades?
Bob Johns -- 8/6/2012, 7:22 pm
Re: Paddle: Ply for blades?
ancient kayaker -- 8/6/2012, 8:59 pm