: I put the the third fill coat on the deck using
: "squeegee" and foam brush to paint the ends. The
: result was ridges surrounded by dips at the edge of each pass. I
: sanded most of it flat but their is still some very visible dips
: which if I sand any more it starts cutting in to the fibre.

: Questions:
: What should have I used to apply the fill coats? I tried the foam
: roller once and it jut foamed up the epoxy like no other...

: How should I paint on a final seal/ levelling coat of epoxy? This
: is to seal the fibres I cut into her and their and get it to a
: point where I can sand it smooth. I am using Raka slow setting
: epoxy and wont be able to get back to it until hour 36 or 40
: after the last coat of epoxy. I have been doing a coat every 8
: to 12 hours to get chemical bond.

: How many fill coats of epoxy do you use and much do you rely on the
: varnish to level things out?

: Full size image:
: http://jasonrmoore.info/pix/strip_built_kayak/DSCN0269.JPG

I roll on a coat using west roller covers, then instead of tipping off with a brush I use a blow torch to Pop the bubbles and even the roller marks. I believe the more acceptable practice it to use a heat gun for this. Although the blow torch technique was featured in epoxy works magazine.

Dave g