Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Skin-on-Frame: 3D printing of SOF components
By:Bill Hamm
Date: 10/14/2012, 1:44 am
In Response To: Re: Skin-on-Frame: 3D printing of SOF components (John Oetting)

: I don't know much about it, but you can find a comparison to ABS on
: the last page of the pdf linked below. It does seem more
: structural than the nylon you describe. Testing is surely
: needed.

:
: http://downloads.makerbot.com/replicator2/MakerBot_Replicator2_faq.pdf

I is to make a model with this and use it as a plug to make a mold to lay fiberglass/epoxy up into?

Bill H.

Messages In This Thread

Skin-on-Frame: 3D printing of SOF components
John Oetting -- 10/12/2012, 2:23 pm
Re: Skin-on-Frame: 3D printing of SOF components
Marc Upchurch -- 10/12/2012, 3:42 pm
Re: Skin-on-Frame: 3D printing of SOF components
John Oetting -- 10/12/2012, 4:09 pm
Re: Skin-on-Frame: 3D printing of SOF components
Bill Hamm -- 10/14/2012, 1:44 am
Re: Skin-on-Frame: 3D printing of SOF components
John Oetting -- 10/14/2012, 11:54 am
Re: Skin-on-Frame: 3D printing of SOF components
Marc Upchurch -- 10/14/2012, 12:37 pm
Re: Skin-on-Frame: 3D printing of SOF components
Bill Hamm -- 10/15/2012, 1:01 am
Re: Skin-on-Frame: 3D printing of SOF components
ancient kayaker -- 10/12/2012, 4:22 pm
Re: Skin-on-Frame: 3D printing of SOF components
John Oetting -- 10/14/2012, 3:26 pm
Re: Skin-on-Frame: 3D printing of SOF components
Bill Hamm -- 10/15/2012, 1:17 am