Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Skin-on-Frame: 3D printing of SOF components
By:Bill Hamm
Date: 10/15/2012, 1:17 am
In Response To: Re: Skin-on-Frame: 3D printing of SOF components (John Oetting)

: Nice article from Wired on 3D printing:

:
: http://www.wired.com/design/2012/09/how-makerbots-replicator2-will-launch-era-of-desktop-manufacturing/all/

It sounds like the "2x" unit will use ABS, not sure if that's what's being sold now, a bit hard to tell from the article. Doesn't sound like it.

Bill H.

Messages In This Thread

Skin-on-Frame: 3D printing of SOF components
John Oetting -- 10/12/2012, 2:23 pm
Re: Skin-on-Frame: 3D printing of SOF components
Marc Upchurch -- 10/12/2012, 3:42 pm
Re: Skin-on-Frame: 3D printing of SOF components
John Oetting -- 10/12/2012, 4:09 pm
Re: Skin-on-Frame: 3D printing of SOF components
Bill Hamm -- 10/14/2012, 1:44 am
Re: Skin-on-Frame: 3D printing of SOF components
John Oetting -- 10/14/2012, 11:54 am
Re: Skin-on-Frame: 3D printing of SOF components
Marc Upchurch -- 10/14/2012, 12:37 pm
Re: Skin-on-Frame: 3D printing of SOF components
Bill Hamm -- 10/15/2012, 1:01 am
Re: Skin-on-Frame: 3D printing of SOF components
ancient kayaker -- 10/12/2012, 4:22 pm
Re: Skin-on-Frame: 3D printing of SOF components
John Oetting -- 10/14/2012, 3:26 pm
Re: Skin-on-Frame: 3D printing of SOF components
Bill Hamm -- 10/15/2012, 1:17 am