Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Strip: Ripping strips with a plunge cut saw
By:Malcolm Schweizer
Date: 4/12/2013, 1:14 pm
In Response To: Strip: Ripping strips with a plunge cut saw *PIC* (Matt Jakubek)

I like the tilted table. Wish I had room for something like this. I have to rip some 20' fir into strips for a birdsmouth sailboat mast. Ironically it is being salvaged from a hollow rectangular mast off a boat that ran aground. Going to be cool to reuse it as a mast for "Scallywag", my pirate treasure hunter to be! Ripping long strips on a table saw is no fun. I am beginning to think a hand circular saw may be the way to go.

Messages In This Thread

Strip: Ripping strips with a plunge cut saw *PIC*
Matt Jakubek -- 4/11/2013, 12:24 pm
Re: Strip: Ripping strips with a plunge cut saw
dave koslow -- 4/11/2013, 3:07 pm
Re: Strip: Ripping strips with a plunge cut saw
Daniel Thaler -- 4/11/2013, 6:01 pm
Re: Strip: Ripping strips with a plunge cut saw
Matt Jakubek -- 4/12/2013, 9:52 am
Re: Strip: Ripping strips with a plunge cut saw
Matt Jakubek -- 4/12/2013, 9:56 am
Re: Strip: Ripping strips with a plunge cut saw
Malcolm Schweizer -- 4/12/2013, 1:14 pm
Re: Strip: Ripping strips with a plunge cut saw *PIC*
Etienne Muller -- 4/12/2013, 2:29 pm
Re: Strip: Ripping strips with a plunge cut saw
Matt Jakubek -- 4/12/2013, 5:59 pm
Re: Strip: Ripping strips with a plunge cut saw
Bill Hamm -- 4/14/2013, 1:29 am
Re: Strip: Ripping strips with a plunge cut saw
Bill Hamm -- 4/15/2013, 2:15 am
Re: Strip: Ripping strips with a plunge cut saw
ddaniels -- 4/14/2013, 10:33 am
Re: Strip: Ripping strips with a plunge cut saw
ancient kayaker -- 4/14/2013, 11:38 am