Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Skin-on-Frame: tenon position
By:William Mayberry
Date: 5/21/2013, 9:28 am
In Response To: Re: Skin-on-Frame: tenon position (Brian Nystrom)

I will hazard a guess that that the original reason for using this method is that it simplifies creating the tenon and reduces the number of saw cuts by half. If I were using primitive tools to build a kayak, I'd probably go the same route. However, I agree with you that from a structural standpoint, putting the tenon in the center of the beam makes it less likely to split off under stress.

That seems like a good explanation of why the tenon is on the edge instead of the middle. Maybe I'll do some of each and see what lasts longer.....:)

Thanks,
Bill

Messages In This Thread

Skin-on-Frame: tenon position
William Mayberry -- 5/20/2013, 9:51 pm
Re: Skin-on-Frame: tenon position
Ken Blanton -- 5/21/2013, 3:41 am
Re: Skin-on-Frame: tenon position
William Mayberry -- 5/21/2013, 9:25 am
Re: Skin-on-Frame: tenon position
Brian Nystrom -- 5/21/2013, 7:00 am
Re: Skin-on-Frame: tenon position
William Mayberry -- 5/21/2013, 9:28 am
Re: Skin-on-Frame: tenon position
ancient kayaker -- 5/21/2013, 11:03 pm
Re: Skin-on-Frame: tenon position
William Mayberry -- 5/21/2013, 11:35 pm
Re: Skin-on-Frame: tenon position
ancient kayaker -- 5/22/2013, 11:38 am
Re: Skin-on-Frame: tenon position
Mike Savage -- 5/22/2013, 3:25 pm
Re: Skin-on-Frame: tenon position
Mark Seilis -- 5/22/2013, 11:00 pm
Re: Skin-on-Frame: tenon position
ancient kayaker -- 5/23/2013, 12:13 pm
Re: Skin-on-Frame: tenon position
Bill Hamm -- 5/26/2013, 3:24 am