Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: S&G: Full coat question
By:Etienne Muller
Date: 6/9/2013, 4:17 am
In Response To: Re: S&G: Full coat question *PIC* (Jennifer Harold)

Any drips or runs can be scraped down with a utility knife blade before sanding. I usually go over the whole hull with a blade knocking off resin bumps before sanding. It doesn't take long. The odd lump in the fill coats will be gone before you varnish.

Et

Messages In This Thread

S&G: Full coat question
Jennifer Harold -- 6/7/2013, 7:47 pm
Re: S&G: Full coat question
Matt Jakubek -- 6/7/2013, 11:01 pm
Re: S&G: Full coat question
Robert N Pruden -- 6/7/2013, 11:49 pm
Re: S&G: Full coat question
Etienne Muller -- 6/8/2013, 4:19 am
Re: S&G: Full coat question
JohnAbercrombie -- 6/8/2013, 11:09 am
Re: S&G: Full coat question
Robert N Pruden -- 6/8/2013, 11:53 am
Re: S&G: Full coat question
Rob Macks/Laughing Loon CC&K -- 6/8/2013, 9:53 am
Re: S&G: Full coat question
Etienne Muller -- 6/8/2013, 1:33 pm
Re: S&G: Full coat question
Jennifer Harold -- 6/8/2013, 11:04 am
Re: S&G: Full coat question
Matt Jakubek -- 6/8/2013, 11:13 am
Re: S&G: Full coat question
Rob Macks/Laughing Loon CC&K -- 6/8/2013, 1:27 pm
Re: S&G: Full coat question
Jennifer Harold -- 6/8/2013, 1:35 pm
Re: S&G: Full coat question
Etienne Muller -- 6/8/2013, 1:41 pm
Re: S&G: Full coat question
Jennifer Harold -- 6/8/2013, 5:16 pm
Re: S&G: Full coat question *PIC*
Jennifer Harold -- 6/8/2013, 9:04 pm
Re: S&G: Full coat question
Etienne Muller -- 6/9/2013, 4:17 am
Re: S&G: Full coat question
Jennifer Harold -- 6/9/2013, 6:28 pm
Re: S&G: Full coat question
Etienne Muller -- 6/9/2013, 6:42 pm
Re: S&G: Full coat question
Jennifer Harold -- 6/10/2013, 12:58 am
Re: S&G: Full coat question
john vanburen -- 6/9/2013, 7:17 am
Re: S&G: Full coat question
Malcolm Schweizer -- 6/9/2013, 11:22 am
Re: S&G: Full coat question
Jennifer Harold -- 6/9/2013, 11:43 am