Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Strip: Help needed with stock power feeder *PIC*
By:Jim Schaffer
Date: 10/19/2013, 7:54 pm
In Response To: Strip: Help needed with stock power feeder (Greg Galloway)

Hi Greg, I used the baby feeder on a router table to mill b&c. Still trying to upload pic of ripping strips with "big" feeder. I was able to place the saw blade between two rollers so as not to cut the rubber wheels.

Jim

Messages In This Thread

Strip: Help needed with stock power feeder
Greg Galloway -- 10/18/2013, 1:20 pm
Re: Strip: Help needed with stock power feeder *PIC*
Etienne Muller -- 10/18/2013, 2:08 pm
Re: Strip: Help needed with stock power feeder
Mike Bielski -- 10/20/2013, 12:54 pm
Re: Strip: Help needed with stock power feeder
Etienne Muller -- 10/20/2013, 2:01 pm
Re: Strip: Help needed with stock power feeder *PIC*
Greg Galloway -- 10/20/2013, 9:17 pm
Re: Strip: Help needed with stock power feeder *PIC*
woodman -- 10/27/2013, 9:30 pm
Re: Strip: Help needed with stock power feeder
Bill Hamm -- 10/31/2013, 9:19 pm
Re: Strip: Help needed with stock power feeder
Chris Reyes -- 11/6/2017, 4:48 pm
Re: Strip: Help needed with stock power feeder
M A Bielski -- 11/8/2017, 12:31 am
Re: Strip: Help needed with stock power feeder *PIC*
Nick Schade - Guillemot Kayaks -- 11/8/2017, 7:21 am
Re: Strip: Help needed with stock power feeder
Chris Reyes -- 11/10/2017, 1:21 pm
Re: Strip: Help needed with stock power feeder *PIC*
Jim Schaffer -- 10/19/2013, 7:54 pm
Re: Strip: Help needed with stock power feeder *PIC*
Jim Schaffer -- 10/19/2013, 8:03 pm