Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Strip: Skeg Control Box - Question for ET *PIC*
By:Etienne Muller
Date: 7/23/2014, 5:34 am
In Response To: Re: Strip: Skeg Control Box - Question for ET (Bob Beaullieu)

I rough that section of the plastic tube up so that it can't slide out.

I just let it run right through the whole setup until it is set up and then I cut the length inside the box out.

Et


Messages In This Thread

Strip: Skeg Control Box - Question for ET
Bob Beaullieu -- 7/22/2014, 4:31 am
Re: Strip: Skeg Control Box - Question for ET *PIC*
Etienne Muller -- 7/22/2014, 11:56 am
Re: Strip: Skeg Control Box - Question for ET
Bob Beaullieu -- 7/23/2014, 5:07 am
Re: Strip: Skeg Control Box - Question for ET *PIC*
Etienne Muller -- 7/23/2014, 5:34 am
Re: Strip: Skeg Control Box - Question for ET
Bill Hamm -- 7/24/2014, 9:13 am
Re: Strip: Skeg Control Box - Question for ET
Bob Beaullieu -- 7/24/2014, 9:21 am
Re: Strip: Skeg Control Box - Question for ET
Bill Hamm -- 7/24/2014, 8:11 pm
Re: Strip: Skeg Control Box - Question for ET *PIC*
Bob Ten Eyck -- 7/23/2014, 10:19 am
Re: Strip: Skeg Control Box - Question for ET
Robert W -- 7/23/2014, 11:00 am
Re: Strip: Skeg Control Box - Question for ET
JohnAbercrombie -- 7/23/2014, 12:44 pm
Re: Strip: Skeg Control Box - Question for ET *PIC*
Etienne Muller -- 7/23/2014, 12:56 pm
Re: Strip: Skeg Control Box - Question for ET
george jung -- 7/23/2014, 1:48 pm
Re: Strip: Skeg Control Box - Question for ET
Robert W -- 7/23/2014, 4:32 pm
Re: Strip: Skeg Control Box - Question for ET *PIC*
Bob Ten Eyck -- 7/23/2014, 5:05 pm
Re: Strip: Skeg Control Box - Question for ET *PIC*
Dan Thaler -- 7/24/2014, 8:11 pm
Re: Strip: Skeg Control Box - Question for ET
onno -- 8/3/2014, 12:03 am