Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Launching: Spring Run finally gets wet
By:Tom Thomas
Date: 11/3/2014, 5:47 pm
In Response To: Re: Launching: Spring Run finally gets wet (Ian Cummins)

Awesome build man! I really like the clean lines and choice of wood colours. Nice lines at the bow as well. What is the overal length? Will you use through the hull fittings (Maroske)for the perimeter lines? I will be using magnets for the hatch as well and I'm glad you are getting a good seal. But I read somewhere that you should drill a small hole in the middle of the bulkhead to vent the air inside when it cools and contracts and vice versa. I like the patterned surface under the hatch too.

Messages In This Thread

Launching: Spring Run finally gets wet *PIC*
Thor -- 11/3/2014, 11:47 am
Re: Launching: Spring Run finally gets wet
Gero Verheyen -- 11/3/2014, 1:44 pm
Re: Launching: Spring Run finally gets wet
george jung -- 11/3/2014, 2:29 pm
Re: Launching: Spring Run finally gets wet
JohnAbercrombie -- 11/3/2014, 3:08 pm
Re: Launching: Spring Run finally gets wet
Ian Cummins -- 11/3/2014, 5:10 pm
Re: Launching: Spring Run finally gets wet
Tom Thomas -- 11/3/2014, 5:47 pm
Re: Launching: Spring Run finally gets wet
Thor -- 11/4/2014, 8:26 am
Re: Launching: Spring Run finally gets wet
JohnAbercrombie -- 11/4/2014, 11:50 am
Re: Launching: Spring Run finally gets wet
Bill Hamm -- 11/4/2014, 4:34 pm
Re: Launching: Spring Run finally gets wet
scottbaxter -- 11/4/2014, 6:08 pm
Re: Launching: Spring Run finally gets wet
Bill Hamm -- 11/4/2014, 10:33 pm
Re: Launching: Spring Run finally gets wet
JohnAbercrombie -- 11/7/2014, 7:48 pm
Re: Launching: Spring Run finally gets wet
Bill Hamm -- 11/8/2014, 6:32 am