Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Some design thoughts
By:scottbaxter
Date: 11/18/2014, 4:04 pm
In Response To: Some design thoughts (Jay Babina)

Jay,with my last build I made a fiberglass lip and intentionally created a space between the gasket and the hull that would allow water to run to the low spot. My intention was to do just as you suggest and put a drain tube from the low spot to the outer edge of the kayak. I also recessed my finger notches over the low spot to make a drain on top of the kayak. The finger notch drain works well enough that I have not made the side drains.

Messages In This Thread

Strip: hatch covers not flush to surface
Jay -- 11/18/2014, 7:39 am
Re: Strip: hatch covers not flush to surface
Jay Babina -- 11/18/2014, 7:58 am
Re: Strip: hatch covers not flush to surface
Rod Tait -- 11/18/2014, 10:37 am
Re: Strip: The Secert *PIC*
Rob Macks/Laughing Loon CC&K -- 11/18/2014, 10:47 am
Re: Strip: The Secert
george jung -- 11/18/2014, 11:37 am
Re: Strip: The Secert *PIC*
Rob Macks/Laughing Loon CC&K -- 11/18/2014, 12:09 pm
Re: Strip: The Secert
Paul Davies -- 11/18/2014, 12:14 pm
Re: Strip: The Secert
Thomas Duncan -- 11/20/2014, 9:49 am
Re: Strip: The Secert
Jay Stallman -- 11/18/2014, 12:41 pm
Re: Strip: The Secert
Daniel Thaler -- 11/18/2014, 12:49 pm
Re: Strip: The Secert
Jay Stallman -- 11/18/2014, 5:03 pm
Re: Strip: The Secert
Rob Macks/Laughing Loon CC&K -- 11/18/2014, 12:55 pm
Some design thoughts
Jay Babina -- 11/18/2014, 3:33 pm
Re: Some design thoughts
Bob Ten Eyck -- 11/18/2014, 3:49 pm
Re: Some design thoughts
scottbaxter -- 11/18/2014, 4:04 pm
Re: Some design thoughts
george jung -- 11/18/2014, 4:54 pm
Re: Some design thoughts *PIC*
Rob Macks/Laughing Loon CC&K -- 11/18/2014, 5:57 pm
Re: Some design thoughts
george jung -- 11/18/2014, 6:21 pm
Re: Some design thoughts
Rob Macks/Laughing Loon CC&K -- 11/18/2014, 7:04 pm
Re: Some design thoughts
Bill Hamm -- 11/19/2014, 1:28 am
Re: Some design thoughts
george jung -- 11/19/2014, 8:39 am
Re: Some design thoughts
Bill Hamm -- 11/23/2014, 1:51 am
Re: Some design thoughts
Paul Davies -- 11/19/2014, 2:06 am