Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Some design thoughts *PIC*
By:Rob Macks/Laughing Loon CC&K
Date: 11/18/2014, 5:57 pm
In Response To: Re: Some design thoughts (george jung)

I was thinking something similar - filing down or sanding a 'groove' from the side of the hatch, same level as the inner lip - which would drain down the outside of the hull. Glue some interesting wood on the underside of the deck, to accommodate this, as well.

Yes, that works.

Messages In This Thread

Strip: hatch covers not flush to surface
Jay -- 11/18/2014, 7:39 am
Re: Strip: hatch covers not flush to surface
Jay Babina -- 11/18/2014, 7:58 am
Re: Strip: hatch covers not flush to surface
Rod Tait -- 11/18/2014, 10:37 am
Re: Strip: The Secert *PIC*
Rob Macks/Laughing Loon CC&K -- 11/18/2014, 10:47 am
Re: Strip: The Secert
george jung -- 11/18/2014, 11:37 am
Re: Strip: The Secert *PIC*
Rob Macks/Laughing Loon CC&K -- 11/18/2014, 12:09 pm
Re: Strip: The Secert
Paul Davies -- 11/18/2014, 12:14 pm
Re: Strip: The Secert
Thomas Duncan -- 11/20/2014, 9:49 am
Re: Strip: The Secert
Jay Stallman -- 11/18/2014, 12:41 pm
Re: Strip: The Secert
Daniel Thaler -- 11/18/2014, 12:49 pm
Re: Strip: The Secert
Jay Stallman -- 11/18/2014, 5:03 pm
Re: Strip: The Secert
Rob Macks/Laughing Loon CC&K -- 11/18/2014, 12:55 pm
Some design thoughts
Jay Babina -- 11/18/2014, 3:33 pm
Re: Some design thoughts
Bob Ten Eyck -- 11/18/2014, 3:49 pm
Re: Some design thoughts
scottbaxter -- 11/18/2014, 4:04 pm
Re: Some design thoughts
george jung -- 11/18/2014, 4:54 pm
Re: Some design thoughts *PIC*
Rob Macks/Laughing Loon CC&K -- 11/18/2014, 5:57 pm
Re: Some design thoughts
george jung -- 11/18/2014, 6:21 pm
Re: Some design thoughts
Rob Macks/Laughing Loon CC&K -- 11/18/2014, 7:04 pm
Re: Some design thoughts
Bill Hamm -- 11/19/2014, 1:28 am
Re: Some design thoughts
george jung -- 11/19/2014, 8:39 am
Re: Some design thoughts
Bill Hamm -- 11/23/2014, 1:51 am
Re: Some design thoughts
Paul Davies -- 11/19/2014, 2:06 am