Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Strip: Stem end bending
By:Bill Hamm
Date: 12/20/2016, 12:40 am
In Response To: Re: Strip: Stem end bending (Jan Jensen)

Easiest way is to rip it into thin strips and laminate it. If you use a band saw to rip it (thin kerf) and keep track of the order of the strips it'll be very difficult to tell once bent into place that it wasn't bent as a solid piece.

Bill H.

Messages In This Thread

Strip: Stem end bending
Jan Jensen -- 12/17/2016, 6:32 pm
Re: Strip: Stem end bending
Paul -- 12/17/2016, 7:17 pm
Re: Strip: Stem end bending
anewhouse -- 12/17/2016, 8:31 pm
Re: Strip: Stem end bending
Jan Jensen -- 12/17/2016, 9:00 pm
Re: Strip: Stem end bending
JohnK -- 12/17/2016, 9:20 pm
Re: Strip: Stem end bending
Jan Jensen -- 12/18/2016, 4:00 am
Re: Strip: Stem end bending
Etienne Muller -- 12/18/2016, 4:08 am
Another great video *M*
jaybabina -- 12/18/2016, 8:32 am
Re: Another great video *M*
scottbaxter -- 12/18/2016, 10:43 am
Re: Strip: Stem end bending
Jan Jensen -- 12/18/2016, 4:29 pm
Re: Strip: Stem end bending
anewhouse -- 12/18/2016, 4:19 am
Try again *PIC*
anewhouse -- 12/18/2016, 4:21 am
Re: Strip: Stem end bending
Thomas Duncan -- 12/18/2016, 9:44 am
Re: Strip: Stem end bending *NM*
Nick R. -- 12/18/2016, 3:49 pm
Re: Strip: Stem end bending
Jan Jensen -- 12/18/2016, 4:40 pm
Re: Strip: Stem end bending
Bill Hamm -- 12/20/2016, 12:40 am
Re: Strip: Stem end bending *PIC*
Dan Caouette (CSCWC) -- 12/20/2016, 9:04 am
Re: Strip: Stem end bending
Jan Jensen -- 12/20/2016, 4:16 pm
Re: Strip: Stem end bending
Dan Caouette (CSCWC) -- 12/20/2016, 4:30 pm
Re: Strip: Stem end bending
Jan Jensen -- 12/21/2016, 5:57 am