Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Material: Using a roller for automotive clear
By:Mike Bielski
Date: 1/1/2017, 9:53 am
In Response To: Re: Material: Using a roller for automotive clear (Paul T)

Then your experience trumps mine. I have used catalyze finishes for commercial wood finishing, and they would not work in any other than spray application. For marine finishes I have used Awlcraft 2000, which again is not intended for any other application method. I don't know the official dry times with the wood products because they were so dependent on temp and humidity, but the Awlcraft flashes off and is ready for recital in 15 minutes. If there is something that has a longer open time it might work.

m

Messages In This Thread

Material: Using a roller for automotive clear
Paul T -- 12/31/2016, 5:20 pm
Re: Material: Using a roller for automotive clear
Marc Upchurch -- 12/31/2016, 7:07 pm
Re: Material: Using a roller for automotive clear
Mike Bielski -- 12/31/2016, 8:51 pm
Re: Material: Using a roller for automotive clear
Paul T -- 12/31/2016, 9:06 pm
Re: Material: Using a roller for automotive clear
Mike Bielski -- 1/1/2017, 9:53 am
Re: Material: Using a roller for automotive clear
JohnAbercrombie -- 1/1/2017, 10:19 am
Re: Material: Using a roller for automotive clear
Dan Caouette (CSCWC) -- 1/1/2017, 12:42 pm
Re: Material: Using a roller for automotive clear
Nick R. -- 1/1/2017, 2:41 pm
Re: Material: Using a roller for automotive clear
Marc Upchurch -- 1/1/2017, 2:43 pm
Re: Material: Using a roller for automotive clear
Paul T -- 1/1/2017, 6:36 pm
Re: Material: Using a roller for automotive clear
Paul T -- 1/1/2017, 6:43 pm
Re: Material: Using a roller for automotive clear *PIC*
Paul T -- 1/4/2017, 8:12 pm
Re: Material: Using a roller for automotive clear
Bill Hamm -- 1/6/2017, 3:14 am
Re: Material: Using a roller for automotive clear
Marc Upchurch -- 1/6/2017, 6:46 am
Re: Material: Using a roller for automotive clear *PIC*
Paul T -- 1/6/2017, 7:25 am
Re: Material: Using a roller for automotive clear
Dan Caouette (CSCWC) -- 1/6/2017, 10:02 am
Re: Material: Using a roller for automotive clear
Marc Upchurch -- 1/6/2017, 11:04 am
Re: Material: Using a roller for automotive clear
Roy Martin -- 1/6/2017, 11:35 am
Re: Material: Using a roller for automotive clear
Paul T -- 1/6/2017, 12:54 pm
Re: Material: Using a roller for automotive clear
Paul T -- 1/6/2017, 12:41 pm