Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Strip: Fiberglassing problem
By:Aaronpotter
Date: 5/1/2017, 12:17 pm
In Response To: Re: Strip: Fiberglassing problem (Etienne Muller)

I took 4 years of French in high school but I don't remember any of the words that would have been used in that situation. The hull only dropped about 6 inches before it hit the cross bar on the cradle. But that was enough to do the damage. It took me a year to recover before I started working on the boat again.

Messages In This Thread

Strip: Fiberglassing problem *PIC*
Aaronpotter -- 4/29/2017, 8:14 pm
Re: Strip: Fiberglassing problem
Bob Ten Eyck -- 4/30/2017, 12:12 am
Re: Strip: Fiberglassing problem
Etienne Muller -- 4/30/2017, 3:36 am
Re: Strip: Fiberglassing problem
Etienne Muller -- 4/30/2017, 3:41 am
Re: Strip: Fiberglassing problem
Nick Schade - Guillemot Kayaks -- 4/30/2017, 7:37 am
Question: Fiberglassing problem
JayBabina -- 4/30/2017, 8:36 am
Re: Question: Fiberglassing problem
Aaronpotter -- 4/30/2017, 9:05 am
Re: Question: Fiberglassing problem
JayBabina -- 4/30/2017, 12:11 pm
Re: Strip: Fiberglassing problem
Rob Macks/Laughing Loon CC&K -- 4/30/2017, 12:26 pm
Re: Strip: Fiberglassing problem
Etienne Muller -- 4/30/2017, 5:18 pm
Re: Strip: Fiberglassing problem
Rob Macks/Laughing Loon CC&K -- 4/30/2017, 6:58 pm
Re: Strip: Fiberglassing problem
Nick Schade - Guillemot Kayaks -- 5/1/2017, 10:10 am
Re: Strip: Fiberglassing problem *PIC*
Rob Macks/Laughing Loon CC&K -- 5/1/2017, 12:46 pm
Re: Strip: Fiberglassing problem *PIC*
Dave Gentry -- 5/1/2017, 11:30 am
Re: Strip: Fiberglassing problem
Aaronpotter -- 4/30/2017, 8:22 pm
Re: Strip: Fiberglassing problem
Etienne Muller -- 5/1/2017, 3:14 am
Re: Strip: Fiberglassing problem
Aaronpotter -- 5/1/2017, 12:17 pm
Recovery from Major Mistakes
Nick Schade - Guillemot Kayaks -- 5/1/2017, 2:18 pm
Re: Recovery from Major Mistakes *PIC*
Rob Macks/Laughing Loon CC&K -- 5/1/2017, 2:51 pm
Re: Recovery from Major Mistakes
Etienne Muller -- 5/1/2017, 2:52 pm