Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Material: Maroske fittings
By:Etienne Muller
Date: 6/19/2017, 3:39 pm
In Response To: Re: Material: Maroske fittings (JohnAbercrombie)

I'm guessing some plastics might stick to epoxy, but I never had a problem with the ice tray molds. It is more that vacuum power will stop them from wanting to come off. You have to lever up an edge and let air in.

I have a perfect ice tray for maroskes which I cut up for molds. Perfect size and shape. I drilled 1/4 inch holes in the deepest part of the molds to allow excess epoxy mix out. I keep looking for more of the same shape, but so far have had no luck, even online.

Et

Messages In This Thread

Material: Maroske fittings
Aaron Potter -- 6/18/2017, 10:37 pm
Re: Material: Maroske fittings
JayBabina -- 6/19/2017, 6:07 am
Re: Material: Maroske fittings
Aaronpotter -- 6/19/2017, 12:56 pm
Re: Material: Maroske fittings
Etienne Muller -- 6/19/2017, 2:28 pm
Re: Material: Maroske fittings
JohnAbercrombie -- 6/19/2017, 2:49 pm
Re: Material: Maroske fittings
Etienne Muller -- 6/19/2017, 3:39 pm
Re: Material: Maroske fittings *PIC*
Scott Innes -- 11/26/2017, 8:48 pm
Re: Material: Maroske fittings
Etienne Muller -- 11/27/2017, 4:04 am
De-Reske Fittings
mick allen -- 6/19/2017, 3:58 pm
Ping pong recesses
jayBabina -- 6/19/2017, 4:30 pm
DeReske vs Pongesque
mick allen -- 6/19/2017, 5:46 pm
Maroske fittings: 3D Printed *PIC*
Dan Caouette (CSCWC) -- 6/20/2017, 8:26 am
Re: Maroske fittings: 3D Printed
JohnAbercrombie -- 6/20/2017, 11:42 am
Re: Maroske fittings: 3D Printed
Etienne Muller -- 6/20/2017, 12:10 pm
Re: Maroske fittings: 3D Printed
Dan Caouette (CSCWC) -- 6/20/2017, 12:29 pm
Re: Maroske fittings: 3D Printed
JohnAbercrombie -- 6/20/2017, 6:23 pm
Re: Maroske fittings: 3D Printed *PIC*
Dan Caouette (CSCWC) -- 6/21/2017, 7:56 am
Re: Maroske fittings: 3D Printed
Etienne Muller -- 6/20/2017, 12:30 pm
Re: Maroske fittings: 3D Printed
Etienne Muller -- 6/20/2017, 12:31 pm
Re: Maroske fittings: 3D Printed
Dan Caouette (CSCWC) -- 6/20/2017, 12:15 pm