Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Maroske fittings: 3D Printed *PIC*
By:Dan Caouette (CSCWC)
Date: 6/20/2017, 8:26 am
In Response To: Re: Material: Maroske fittings (Etienne Muller)

I had a customer last fall ask me to use 3D printed Maroskes in his strip Frej. Talk about easy to install: Just drill two holes, bond the fitting to the underside of the deck, trim the exterior.

For the first batch he had some bases made. They would be superglued to the legs of the fitting and then those would be bonded to the deck. In the end we went low profile and just bonded the fitting itself to the deck.




Messages In This Thread

Material: Maroske fittings
Aaron Potter -- 6/18/2017, 10:37 pm
Re: Material: Maroske fittings
JayBabina -- 6/19/2017, 6:07 am
Re: Material: Maroske fittings
Aaronpotter -- 6/19/2017, 12:56 pm
Re: Material: Maroske fittings
Etienne Muller -- 6/19/2017, 2:28 pm
Re: Material: Maroske fittings
JohnAbercrombie -- 6/19/2017, 2:49 pm
Re: Material: Maroske fittings
Etienne Muller -- 6/19/2017, 3:39 pm
Re: Material: Maroske fittings *PIC*
Scott Innes -- 11/26/2017, 8:48 pm
Re: Material: Maroske fittings
Etienne Muller -- 11/27/2017, 4:04 am
De-Reske Fittings
mick allen -- 6/19/2017, 3:58 pm
Ping pong recesses
jayBabina -- 6/19/2017, 4:30 pm
DeReske vs Pongesque
mick allen -- 6/19/2017, 5:46 pm
Maroske fittings: 3D Printed *PIC*
Dan Caouette (CSCWC) -- 6/20/2017, 8:26 am
Re: Maroske fittings: 3D Printed
JohnAbercrombie -- 6/20/2017, 11:42 am
Re: Maroske fittings: 3D Printed
Etienne Muller -- 6/20/2017, 12:10 pm
Re: Maroske fittings: 3D Printed
Dan Caouette (CSCWC) -- 6/20/2017, 12:29 pm
Re: Maroske fittings: 3D Printed
JohnAbercrombie -- 6/20/2017, 6:23 pm
Re: Maroske fittings: 3D Printed *PIC*
Dan Caouette (CSCWC) -- 6/21/2017, 7:56 am
Re: Maroske fittings: 3D Printed
Etienne Muller -- 6/20/2017, 12:30 pm
Re: Maroske fittings: 3D Printed
Etienne Muller -- 6/20/2017, 12:31 pm
Re: Maroske fittings: 3D Printed
Dan Caouette (CSCWC) -- 6/20/2017, 12:15 pm