Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Strip: Help needed with stock power feeder
By:Chris Reyes
Date: 11/10/2017, 1:21 pm
In Response To: Re: Strip: Help needed with stock power feeder (Chris Reyes)

Hello.
Thanks for response. I apologize: I was not clear in my original question. I have already mounted a power feeder.

For the scribe trim pictured above by Woodman (where I would remove the center wheel of feeder), how is this aux fence secured? It looks like it just catches on edge of table saw (operator side) and is perhaps just pushed into actual fence by angle of feeder?

Messages In This Thread

Strip: Help needed with stock power feeder
Greg Galloway -- 10/18/2013, 1:20 pm
Re: Strip: Help needed with stock power feeder *PIC*
Etienne Muller -- 10/18/2013, 2:08 pm
Re: Strip: Help needed with stock power feeder
Mike Bielski -- 10/20/2013, 12:54 pm
Re: Strip: Help needed with stock power feeder
Etienne Muller -- 10/20/2013, 2:01 pm
Re: Strip: Help needed with stock power feeder *PIC*
Greg Galloway -- 10/20/2013, 9:17 pm
Re: Strip: Help needed with stock power feeder *PIC*
woodman -- 10/27/2013, 9:30 pm
Re: Strip: Help needed with stock power feeder
Bill Hamm -- 10/31/2013, 9:19 pm
Re: Strip: Help needed with stock power feeder
Chris Reyes -- 11/6/2017, 4:48 pm
Re: Strip: Help needed with stock power feeder
M A Bielski -- 11/8/2017, 12:31 am
Re: Strip: Help needed with stock power feeder *PIC*
Nick Schade - Guillemot Kayaks -- 11/8/2017, 7:21 am
Re: Strip: Help needed with stock power feeder
Chris Reyes -- 11/10/2017, 1:21 pm
Re: Strip: Help needed with stock power feeder *PIC*
Jim Schaffer -- 10/19/2013, 7:54 pm
Re: Strip: Help needed with stock power feeder *PIC*
Jim Schaffer -- 10/19/2013, 8:03 pm