Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Material: Maroske fittings *PIC*
By:Scott Innes
Date: 11/26/2017, 8:48 pm
In Response To: Re: Material: Maroske fittings (Etienne Muller)

Hi Etienne:

I've been all over looking for ice cube trays after seeing your your approach to Maroske fittings. Thought I'd post info about the tray I found... seem very familiar to shots I've seen on your website..

These are available on-line at link... they are 2.25 in (5.7 cm) long.. https://www.amazon.com/OXO-Good-Grips-Covered-Cube/dp/B00004OCLA/ref=sr_1_3?ie=UTF8&qid=1511745885&sr=8-3&keywords=good+grips+ice+tray

Scott

Messages In This Thread

Material: Maroske fittings
Aaron Potter -- 6/18/2017, 10:37 pm
Re: Material: Maroske fittings
JayBabina -- 6/19/2017, 6:07 am
Re: Material: Maroske fittings
Aaronpotter -- 6/19/2017, 12:56 pm
Re: Material: Maroske fittings
Etienne Muller -- 6/19/2017, 2:28 pm
Re: Material: Maroske fittings
JohnAbercrombie -- 6/19/2017, 2:49 pm
Re: Material: Maroske fittings
Etienne Muller -- 6/19/2017, 3:39 pm
Re: Material: Maroske fittings *PIC*
Scott Innes -- 11/26/2017, 8:48 pm
Re: Material: Maroske fittings
Etienne Muller -- 11/27/2017, 4:04 am
De-Reske Fittings
mick allen -- 6/19/2017, 3:58 pm
Ping pong recesses
jayBabina -- 6/19/2017, 4:30 pm
DeReske vs Pongesque
mick allen -- 6/19/2017, 5:46 pm
Maroske fittings: 3D Printed *PIC*
Dan Caouette (CSCWC) -- 6/20/2017, 8:26 am
Re: Maroske fittings: 3D Printed
JohnAbercrombie -- 6/20/2017, 11:42 am
Re: Maroske fittings: 3D Printed
Etienne Muller -- 6/20/2017, 12:10 pm
Re: Maroske fittings: 3D Printed
Dan Caouette (CSCWC) -- 6/20/2017, 12:29 pm
Re: Maroske fittings: 3D Printed
JohnAbercrombie -- 6/20/2017, 6:23 pm
Re: Maroske fittings: 3D Printed *PIC*
Dan Caouette (CSCWC) -- 6/21/2017, 7:56 am
Re: Maroske fittings: 3D Printed
Etienne Muller -- 6/20/2017, 12:30 pm
Re: Maroske fittings: 3D Printed
Etienne Muller -- 6/20/2017, 12:31 pm
Re: Maroske fittings: 3D Printed
Dan Caouette (CSCWC) -- 6/20/2017, 12:15 pm