Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Tools: Narrow kerf blades.
By:Bill Hamm
Date: 2/9/2018, 1:17 am
In Response To: Re: Tools: Narrow kerf blades. (J Van Buren)

No I did not, I couldn't justify the cost. There are now two of those that I know of and they are worthwhile, but it depends on your budget, they are roughly 3 to 4 times the cost of a conventional table saw. Building the entire inside of a house then a garage and shop, there are lots of tools I needed, just depends on the budget. Suppose it would be different if I were to continue working, then I could have a mortgage, with this house I won't.

Bill H.

Messages In This Thread

Tools: Narrow kerf blades. *PIC*
Etienne Muller -- 2/2/2018, 6:11 am
Re: Tools: Narrow kerf blades.
J Van Buren -- 2/2/2018, 7:45 am
Re: Tools: Narrow kerf blades.
JayBabina -- 2/2/2018, 8:00 am
Re: Tools: Narrow kerf blades.
J Van Buren -- 2/2/2018, 12:37 pm
Re: Tools: Narrow kerf blades.
JayBabina -- 2/2/2018, 5:27 pm
Re: Tools: Narrow kerf blades.
JohnAbercrombie -- 2/2/2018, 8:16 pm
Re: Tools: Narrow kerf blades.
JohnAbercrombie -- 2/2/2018, 8:19 pm
Re: Tools: Narrow kerf blades.
Bill Hamm -- 2/3/2018, 2:04 am
Re: Tools: Narrow kerf blades.
JohnAbercrombie -- 2/3/2018, 11:48 am
Re: Tools: Narrow kerf blades.
Bill Hamm -- 2/5/2018, 12:01 am
Re: Tools: Narrow kerf blades.
J Van Buren -- 2/6/2018, 10:42 am
Re: Tools: Narrow kerf blades.
Bill Hamm -- 2/9/2018, 1:17 am
Re: Tools: Narrow kerf blades.
Etienne Muller -- 2/2/2018, 8:55 am
Re: Tools: Narrow kerf blades.
dave koslow -- 2/2/2018, 1:11 pm
Re: Tools: Narrow kerf blades.
J Van Buren -- 2/2/2018, 1:29 pm
Re: Tools: Narrow kerf blades.
dave koslow -- 2/2/2018, 2:10 pm
Re: Tools: Narrow kerf blades.
JohnAbercrombie -- 2/2/2018, 5:10 pm
Re: Tools: Narrow kerf blades.
scottbaxter -- 2/2/2018, 4:48 pm
Re: Tools: Narrow kerf blades.
Etienne Muller -- 2/2/2018, 6:05 pm
Re: Tools: Narrow kerf blades.
JohnAbercrombie -- 2/2/2018, 8:25 pm
Re: Tools: Narrow kerf blades.
Etienne Muller -- 2/3/2018, 3:25 am