Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Strip: bulkhead shape
By:anewhouse
Date: 3/19/2018, 4:25 pm
In Response To: Re: Strip: bulkhead shape (JohnAbercrombie)

Yes and no.

You can print on a home printer just as you print the forms and glue the A4 sheets together. There are registration marks printed to make alignment accurate.

There is no provision for tilting the bulkhead., but a bit of manual adjustment of the shape makes that possible. The sides stay close to the line and the top and bottom are cut a bit outside the lines.

Messages In This Thread

Strip: bulkhead shape
JayBabina -- 3/18/2018, 7:38 am
Re: Strip: bulkhead shape
Steve Solomon -- 3/18/2018, 10:18 am
Re: Strip: bulkhead shape
JohnAbercrombie -- 3/18/2018, 11:48 am
Re: Strip: bulkhead shape
Steve Solomon -- 3/18/2018, 12:25 pm
Re: Strip: bulkhead shape *PIC*
JohnAbercrombie -- 3/18/2018, 1:22 pm
Re: Strip: bulkhead shape
Bob Ten Eyck -- 3/18/2018, 11:53 am
Re: Strip: bulkhead shape
JohnAbercrombie -- 3/18/2018, 12:02 pm
Re: Strip: bulkhead shape
anewhouse -- 3/19/2018, 4:03 am
Re: Strip: bulkhead shape
JohnAbercrombie -- 3/19/2018, 11:06 am
Re: Strip: bulkhead shape
anewhouse -- 3/19/2018, 4:25 pm
Re: Strip: bulkhead shape
JohnAbercrombie -- 3/19/2018, 8:00 pm
Re: Strip: bulkhead shape
Jim777 -- 3/20/2018, 1:43 pm