Boat Building Forum
Find advice on all aspects of building your own kayak, canoe or any lightweight boats
Re: SCARF JOINT, QUALITY, RADIAL ARM SAW
By:jeff warrick
Date: 11/22/1998, 9:19 pm
Date: 11/22/1998, 9:19 pm
In Response To: SCARF JOINT, QUALITY, RADIAL ARM SAW (Tom Jablonski)
If it is a scarf where you will see the line between the two pieces, like scarfing two pieces of plywood to make a deck or hull piece the seam may wind up looking ratty. Strength should not be an issue.
Messages In This Thread
- SCARF JOINT, QUALITY, RADIAL ARM SAW
Tom Jablonski -- 11/22/1998, 10:47 pm- Re: SCARF JOINT, QUALITY, RADIAL ARM SAW
Don Beale -- 12/1/1998, 12:57 pm- Re: SCARF JOINT, QUALITY, RADIAL ARM SAW
Jay Babina -- 11/30/1998, 11:42 am- What about a router
Mark Bodnar -- 11/23/1998, 9:08 pm- Re: What about a router
Jerry Weinraub -- 11/25/1998, 7:05 am- Re: What about a router
Paul Jacobson -- 11/24/1998, 4:31 am - Re: What about a router
- Re: SCARF JOINT, QUALITY, RADIAL ARM SAW
Mike Scarborough -- 11/22/1998, 10:47 pm- Re: SCARF JOINT, QUALITY, RADIAL ARM SAW
jeff warrick -- 11/22/1998, 9:19 pm - Re: SCARF JOINT, QUALITY, RADIAL ARM SAW
- Re: SCARF JOINT, QUALITY, RADIAL ARM SAW
